Reyray20
Member
So im going to buy some Universal magna flow cats for my HOE. but when i was looking at them i noticed they dont have holes for o2 sensors. what do i have to do if i buy them? do i have to thread the holes?
Universal magna Flow Cats
- Thread starter Reyray20
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
SunlitComet
OBS Jedi-Do Good
Hole them out and weld some sensor bung on them.
Are you sure they did not have a vehicle specific setup available?
Are you sure they did not have a vehicle specific setup available?
Done Deal DR
Full Access Member
- Joined
- Apr 28, 2010
- Posts
- 215
- Reaction score
- 0
They should have a vehicle specific part number available for your truck, though you didn't say what year and model you have.
I have a '92 Blazer and just ordered a generic 94009 generic Magnaflow cat, but I do not have an OBD-II truck.
I have a '92 Blazer and just ordered a generic 94009 generic Magnaflow cat, but I do not have an OBD-II truck.
I thought the o2 sensor was before the cats on a pipe... atleast thats how mine is. im gettign ready to do a 3 inch custom single exhaust and im getting the same cats.
magnaflow makes a aftermarket stainless steel bolt on kit that replaces the old junk... its pretty pricey... i think 600$...
magnaflow makes a aftermarket stainless steel bolt on kit that replaces the old junk... its pretty pricey... i think 600$...
SunlitComet
OBS Jedi-Do Good
OBD2 has pre and post cat sensors on each bank.
Reyray20
Member
I have a 99 4door its a obdll .... ya they have direct bolt on but thats alot 600$ that why im going with the universals get both of them for less than 200 installed.
fyremanpat
Fyremanpat
300 shipped new off ebay
SunlitComet
OBS Jedi-Do Good
As long as your state emission laws are satisfied go for it.
Reyray20
Member
AZ not that strict... in fact were i live i dont even have to do emissions since there not a emission center closer than 25 miles away. i dont even have mine in i just cant stand the check engine light on the smell.. i notice too im getting less gas mileage without them
fyremanpat
Fyremanpat
in some states you cannot use universal cats. in va we cant. ive already tried. the shop wanted 900 for the oem cats and told me it was illegal to cut and weld new ones on...found magnaflows direct replacement on ebay and did it myself for 300.
