Mudsport96's latest activity
-
Mudsport96 replied to the thread Off Roading with an automatic.I will agree that Low Range will ease stress on The transmission. And agree that 95 percent of the time you won't get to 40 mph. But... -
Mudsport96 reacted to Fless's post in the thread My current fuel trims - idle, 2000rpm, 3000rpm all no load with
Like.
Which is why I thought it would be interesting to see 1) if a scanner would show what it thinks the alcohol content is, and 2) how that... -
Mudsport96 replied to the thread My current fuel trims - idle, 2000rpm, 3000rpm all no load.Your 2004 still has the mechanical ethanol sensor, so it will show alcohol content in the fuel. Late 05 and up do not have that sensor...
-
Mudsport96 reacted to Fless's post in the thread My current fuel trims - idle, 2000rpm, 3000rpm all no load with Like.
He doesn't seem to think E85 is available around him, so it may not be an option. But "caveat emptor." He's concerned about high LT...
-
Mudsport96 reacted to 2006Tahoe2WD's post in the thread My current fuel trims - idle, 2000rpm, 3000rpm all no load with Like.
Thanks to everyone putting brain power on this. Yesterday went for a ~100 mile trip and the LTFTs came down a bit. I searched for...
-
Mudsport96 replied to the thread My current fuel trims - idle, 2000rpm, 3000rpm all no load.I will add a caveat. It could be looking for an ethanol content, but that would mean that a no -flex vehicle had a flex ecm installed...
-
Mudsport96 replied to the thread My current fuel trims - idle, 2000rpm, 3000rpm all no load.He will be fine to mix a 1/4 tank of regular to 3/4 tank e85. Yes the trim will max out, but that is the point. To full duty cycle the...
-
Mudsport96 replied to the thread My current fuel trims - idle, 2000rpm, 3000rpm all no load.Sorry for the late reply. I'm thinking you have some poor flowing/ clogged injectors. So the +9 etc. numbers is the ecm trying to make...
-
Mudsport96 replied to the thread Off Roading with an automatic.I would start out with 4 wheel high and put it in drive. If you find that it doesn't leave 1st gear because you are going slow, manually...
-
Mudsport96 replied to the thread Oil Consumption.I think something you should invest in also, is an oil catch can. It goes I line between the pcv valve and the intake manifold. I will...
-
-
Mudsport96 replied to the thread Lifter tick and performance cam swap.And repin of connector( or buy the 60e to 80e jumper connector), and adding a few wires then pinning them to the ecm for the ISS. And...
-
Mudsport96 replied to the thread Oil Consumption.Here is a video of a compression and leak down test. The leak down procedure is close to the end of the video. Compression and leak down...
-
Mudsport96 replied to the thread Oil Consumption.Ok. I looked again. That may possibly be a production flaw that just looks different than the rest of the cylinders. But if you are...
-
Mudsport96 replied to the thread Oil Consumption.I did not see the crack you were speaking about. I believe the valve stem seals are shot by looking at the videos. Also you will see...
-
Mudsport96 replied to the thread My current fuel trims - idle, 2000rpm, 3000rpm all no load.Is this driving/ under load? Or are you in park just revving? All data points need to be taken in a real world scenario, i.e. driving...
