Search results

  1. 0

    Oil leak

    So, I replaced my oil pan gasket when I did my lifters. I developed an oil leak and I have no clue where it's coming from but it's in places it should not me. Like the bottom of my thermostat housing and coolant crossover. Is it maybe leaking from where the timing chain cover and oil pan meet...
  2. 0

    Steering issues

    Is this normal? I've had some play in my steering and sometimes it has a slight pop when I put it into reverse and turn left. I can't find anything else wrong.
  3. 0

    Proper DoD delete oil pump

    So I did the DoD delete and fixed all my post DoD delete issues except for I'm geting really low oil pressure. I did replace the sensor AND the screen with a brand new one. But I'm getting like 10 PSI or less at idle and about 35 PSI while driving. Maybe 40 PSI when I get on it. I'm not sure...
  4. 0

    Please help with post DoD delete problems!!!!

    I did the DoD/AFM delete with the Texas Speed kit. Truck starts and idles fine sometimes and sometimes rough. Has ZERO power. Barely makes it up a hill. Now I'm getting the codes P3449 Cylinder 7 Deactivation solenoid valve control circuit P3441 Cylinder 6 Deactivation solenoid valve control...
  5. 0

    Front differential crack

    Guys, I have a grease pit. I removed my transfer case and dropped it and now the tube has a small crack. Do I have to replace it or can I JB weld the crack? I'm thinking no because the way it's held. I think it may recrack.
  6. 0

    DoD/AFM delete question.

    Replaced my collapsed lifters with OEM style and the truck never would run right. I am now doing the delete and I have 2 questions. 1: Do I just leave the sensor on the valley cover unplugged? 2: What will happen if I drive it without having it tuned out? I'd need to drive it to the shop as I...
  7. 0

    Axxess ASWC-1 programming.

    Does anyone have any experience with this steering wheel control module? I have it wired correctly I'm sure. Pink wire to pin A1 pink wire. Red to red and black to black. The single steering wheel control wire from the head unit to the pink wire, and the 3.5mm jack plugged into the head unit. I...
  8. 0

    Interior paint peeling

    I don't know why this happens but it's activating my OCD bad. Does anyone have a paint brand and code that will match this?
  9. 0

    Gauges draining battery?

    So my battery keeps dying on me. I went to charge it today (dead as shit), and noticed the charger light clicking. So I got in the car with the door shut and this is what I see. Key is OUT of the ignition. The only thing Is the radio is disconnected because I was going to swap in a new one. No...
  10. 0

    Ecoder motor splines

    Ok I'm replacing my encoder motor. The splines coming out of the transfer case are supposed to turn fairly easily, however, my will not. I was too afraid to try and turn it with pliers as I don't want to mess anything up. What should I do based on other member's experiences?
  11. 0

    Strange creaking noise from brakes

    New brake pads, new rotors, new calipers, parking brakes removed. It was doing this before the brake work. Still doing it. No brakes were applied during the video.
  12. 0

    Help with rear brakes

    Have a 2003 suburban that says it's a z71. I ordered z71 rear brakes and rotors. The rotors are much thicker and the pads seem to be for a dual piston caliper. Can I upgrade to the larger rear discs and calipers without any other mods than the new rotor and caliper? And what caliper should I...
  13. 0

    03 suburban stuck in 4wd auto

    03 suburban stuck in 4wd auto. Sometimes the DIC says service 4 wheel drive but most times it does not. If I try to click the other buttons the lights just flash. I'd really like to avoid shooting the parts cannon at this one because I just got through doing that with my 2007 Avalanche.
  14. 0

    Yukon seats in Suburban

    I have a 2004 Yukon XL with full power motion seats and a 2003 Suburban that has only power for moving the seat forward and back. Would I be able to swap in my Yukon seats and have the full range of motion powered? I would just deal with it but the suburban seats are pretty screwed.
  15. 0

    P0175

    Replaced my lifters and now getting a P0175 code. As a side note, I also replaced the purge valve and charcoal canister at the same time as well as coil packs and injectors. I'm not sure if anything I have done would have caused this or if its just one of those things where if you fix one thing...
  16. 0

    rear wiper

    This morning I noticed my rear wiper motor was clicking. Car was off and the knob wasn't turned. My rear wiper hasn't worked since I got the truck. Anyway, I pressed in on the plug coming out of the body and the clicking stopped. I removed the rubber gromet and inspected the wires and I could...
  17. 0

    Driver information center question

    I'd like to know if the driver information center is pulling from the PCM? I have a Yukon XL to play with now and wanted to do a gen IV 5.3 swap and use the Holley Terminator X Max harness and PCM along with the 7" digital display. The digital display so far does literally everything the D.I.C...
  18. 0

    Leak in headliner near sunvisor

    So I have no sunroof. My headliner is coming undone right where it meets the windshield. When it rains heavy I noticed a drip from both the drivers side and passenger side right in front of the visors where where it meets the windshield. I peeked under it best I could and everything seemed fine...
  19. 0

    2003 Yukon XL SLT DIC and climate control backlights not working

    So I did a search and didn't see anything specific that has the exact issues as mine.... So I literally just bought the truck. I bought it to get the engine and transmission for a swap but the family likes it and want's me to fix the issues. I'm very new to this chassis. My only other GM is a...

Forum statistics

Threads
129,551
Posts
1,817,584
Members
92,781
Latest member
Texas_Made

Latest posts

Top