Wiring Schematics 2015+

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

Turbotoys

Supporting Member
Joined
Sep 20, 2014
Posts
36
Reaction score
6
Location
Minnesota
Here are the wiring schematics for the Stereo and Amp. If anyone wants any other wiring let me know and I will post em up.

Radio

RadioX1.jpg

RadioX2.jpg

RadioX3.jpg

Amp - it is located behind the jack bracket in the rear of the vehicle.

AmpX1.jpg

AmpX2.jpg

AmpX3.jpg

AmpX4.jpg
 

Anon2015

Full Access Member
Joined
Oct 11, 2014
Posts
112
Reaction score
1
Very interesting. Multiple subwoofers in the same room (vehicle) perform in some very interesting ways when given the same signal. This is a common technique used to clean up modal response problems. The remaining question is which one, or both, are being used for ANC.
 

Rush

Supporting Member
Joined
Nov 7, 2014
Posts
177
Reaction score
20
Location
NC
We definitely know T3/X1 is being used. Don't know about the others.
 
OP
OP
T

Turbotoys

Supporting Member
Joined
Sep 20, 2014
Posts
36
Reaction score
6
Location
Minnesota
Fog Lights

Here is the Fog Lights

FogLights.jpg

---------- Post added at 08:13 PM ---------- Previous post was at 07:52 PM ----------

Very interesting. Multiple subwoofers in the same room (vehicle) perform in some very interesting ways when given the same signal. This is a common technique used to clean up modal response problems. The remaining question is which one, or both, are being used for ANC.

There is only 1 Subwoofer - if you look at the diagram above there is only 1 positive and a negative for subwoofer. There must be a misprint or they are using a postive signal from the one side and a negative from the other side to sum a mono channel to the subwoofer.

Look at the following sheets - no mention of a second subwoofer.

SpeakerPlacement1.jpg

SpeakerPlacement2.jpg
 

blackout07

Full Access Member
Joined
Sep 28, 2014
Posts
192
Reaction score
4
Location
Beaumont, TX
Thanks. Rick. Looking at the fog schematic, does that more or less mean that the fog lights are controlled by the BCM? And wiring after the fact would be more complicated and require programming?
 
Last edited:
OP
OP
T

Turbotoys

Supporting Member
Joined
Sep 20, 2014
Posts
36
Reaction score
6
Location
Minnesota
Im pretty sure everything is controlled by the BCM :jester:

Are you trying to add factory fog lamps?
 

Forum statistics

Threads
132,200
Posts
1,863,835
Members
96,720
Latest member
canjo
Top