-
-
WIt almost sounds like too much preload to me. It's been a LONG time since I had one apart, but there are specific procedures to follow...
-
WwalterL replied to the thread Rebuilt Differential Help.I had a preload between 20-25 in/lbs. I will give this a shot as well. I have to get this going right so all the advice I can get is...
-
WAdd a bottle of limited slip to it Did you break it in ??? Needs to be driven slowly in a wide figure 8 pattern several times...
-
WwalterL replied to the thread Rebuilt Differential Help.This was my 1st diff. to rebuild. I have only driven slow(45mph) with it, but did not do fig. 8's. I did use Valvoline synthetic oil for...
-
WHi Guys. I just rebuilt my GU4/G80 read differential on my 2011 Tahoe. 1st couple of days all was fine, super quiet, no rattling...
-
WwalterL replied to the thread 2011 Tahoe Spider Gear lineup.Hello again, Gents. I said I would come back with an update and here it is. I finally got the carrier reassembled. My mistake was...
-
WwalterL replied to the thread 2011 Tahoe Spider Gear lineup.Does anyone know the right stacking sequence for the differential clutch pack?
-
WHi guys. This is my 1st time getting in to a differential and was wondering how to properly stack the clutch pack. Thanks in advance
-
WwalterL replied to the thread 2011 Tahoe Spider Gear lineup.I didn't use any special tools to remove the gov locks just a long skinny punch to tap out the pins. Then I used a small magnet to...
-
WDid you remove the governor first? I thought that was the first step to servicing the internals of the carrier? I have to buy the...
-
WwalterL replied to the thread 2011 Tahoe Spider Gear lineup.It is a 3.08 limited slip posi with the gov locks. There are 2 marks on the spider gears and on the side gears inside the differential...
-
W"Marks on the gear to line them up"? Never heard of this? What axle is this? The shims/spacers are supposed to be tight fit, to...
-
WOn the spider gears, as you roll them in.... You'll want one gear turning one way and the other turning the opposite way. When...
-
WMaybe try it once without the thrust washers to get the feel of it
-
WwalterL replied to the thread 2011 Tahoe Spider Gear lineup.Thanks for the advice I will try again. When I read about the marks on the side gears and spider gears I thought they may need to be...
-
-
Loading…
-
Loading…
