-
-
BI agree with @OR VietVet and @strutaeng with their approach. Reason I ask about your trans is the possibility (or probability) of it...
-
BPlease read through this recent thread: https://www.tahoeyukonforum.com/threads/baffling-oil-leak.150783/#post-1914303 RMS leak is hard...
-
BMines an 03 z71 with 208k miles. I believe it’s still the original trans and everything. I’ll try using a mirror today and see if I can...
-
BThat oil cooler block off plate is a horrible design, cheap warped metal that I've replaced gaskets on a few times... a billet...
-
BRear main seal is a common leak for vehicles as they get up in age and/mileage and can be difficult to pin point. Other locations may...
-
BThanks man! I found out it was a broken belt In the sidewall!
-
Bblondie70 reacted to RST Dana's post in the thread What did you do to your 2015-2020 K2XX Tahoe/Yukon Today? with
Like.
So, I had 100 miles before my powertrain warranty expired (100k) and took my RST into service for what I felt may have been a... -
BIt is not a problem by any means but I had to ask. The worst is when people post a response or question and it is one long sentence that...
-
BI Will Try That Next, Thank You. I Did Figure Out That My Drivers Side Door Hinges Seem To Be Loose, I Can Lift Up The Door As I Go To...
-
BIt’s Just Something I’ve Always Done, Even When Writing On Paper. My Teachers Hated It When I Was In School, But No Matter How Hard I...
-
BI have to go with what @Big Mama said. That is the obvious place to start. Sometimes they gum up and they don't move freely but can be...
-
BWelcome to the forum from Virginia. It sounds like the plunger or door contact is failing or has a loose connection. Check it and it’s...
-
BThanks for that comment B-train. I had checked the fluid level (running cold) and was right in the hashes. The rig is in the hands of...
-
BOn my 09 I’ve got 4 new ac Delco o2 sensors plus all new injectors, new gaskets on lifter valley, intake and exhaust manifold. New map...
-
BI'd suggest the flowmaster pro series 3". That's what I have on my 6.2 with tsp long tubes, cats and 3" all the way out. Even with...
-
-
Loading…
-
Loading…
