-
-
Ggregsmy replied to the thread HVAC fault codes question..Forgot to mention that the oil pressure sensor had a small amount of oil inside the connector area. It seems like it leaked past the...
-
Ggregsmy replied to the thread HVAC fault codes question..So the evap temp sensor definitely solved the problem. If I didnt have the scan tool to see what temperature it was reading, I am sure I...
-
Ggregsmy replied to the thread HVAC fault codes question..Next update for the HVAC codes / problem. I got the new evap sensor and worked on installing it. Found a rubber plug that fit a 1-3/4"...
-
Ggregsmy replied to the thread AC charge question..I got the new evap sensor and worked on installing it. Found a rubber plug that fit a 1-3/4" hole. So I used a holesaw and carefully...
-
GNot hard to access. The rubber boot disconnects at the jam area from a plastic collar. Pull off and pull back. If you need the boot off...
-
Ggregsmy replied to the thread HVAC fault codes question..Update on the door control problem. Did some research and testing and figured out there is a broken wire in the harness where the door...
-
Ggregsmy replied to the thread AC charge question..Per the service manual it’s like a 7hr job. Found some videos and information to cut a hole and fish the old one out and the new one in.
-
Ggregsmy replied to the thread AC charge question..Did more research on my issue with the drier freezing up. With my scan tool I went in and checked anything related to the HVAC and found...
-
Ggregsmy replied to the thread HVAC fault codes question..I was investigating the U0200-00 code for the door control module B communication. First I was trying to figure out which module that is...
-
Ggregsmy replied to the thread HVAC fault codes question..Update on the actuator codes. I used my scan tool to go in and test them and just look to see what I could do with it. After that I did...
-
Ggregsmy replied to the thread HVAC fault codes question..Did a little thinking and then some research. I think the B1000 3C code in the ECU may be from the tuner "switching off" the AFM within...
-
Ggregsmy replied to the thread HVAC fault codes question..This what I found from the manual: DTC B1000 3C - Electronic Control Unit (ECU) Performance Internal Communications Failure...
-
Ggregsmy replied to the thread HVAC fault codes question..This is true. I think I have the old one I removed that was probably the original. I only replaced it because it was a known issue and...
-
Ggregsmy replied to the thread HVAC fault codes question..For the HVAC actuators, I think I figured out that: B0413 = Drivers Side air temperature actuator B0433 = Auxiliary air temperature...
-
Ggregsmy replied to the thread HVAC fault codes question..I got the burb from a friend after the transmission died. It has a lot of miles and needed a fair bit of work other than the trans. So I...
-
-
Loading…
-
Loading…
