-
-
Shubbydog replied to the thread 2003 Yukon XL 4x4 Pop clunk issue.Yes sir just in case you have to weld a nut to the end of the fill plug because it stripped out from being seized up and you can no... -
Shubbydog replied to the thread … door locks gone crazy.#44 in the passenger side fuse box is door window motor. I think that relay is for right side doors and windows. If there is a bad or...
-
Shubbydog replied to the thread Front HVAC turning on and off when accelerating..I just had a newer Chevy 2500 that had very similar issues. The a/c would randomly turn off then randomly back on. It turned out that...
-
Shubbydog reacted to lilsettals's post in the thread Front HVAC turning on and off when accelerating. with
Like.
This is my Yukon -
you might want to check the x1 connector passenger side and see if there is corrosion or maybe bad connection in there. all the pins to...
-
Shubbydog replied to the thread Troubleshooting Power Door Locks.You should get 12v to the actuator.
-
Shubbydog replied to the thread What did you do to your OBS GMT400 Tahoe/Yukon Today?.Stretched her legs
-
-
Shubbydog reacted to Doubeleive's post in the thread Front HVAC turning on and off when accelerating. with Like.
unless he lives in florida or the desert I don't think he's trying to make it colder.
-
Shubbydog reacted to swathdiver's post in the thread Overheating 08 Tahoe when driving slow with Like.
There are 3 relays that run both fans on the Low or High settings. Make sure they are all working and the fans. If you have the K5L...
-
Shubbydog replied to the thread 2003 Yukon XL 4x4 Pop clunk issue.check rear end. Also pull the drain plug from the front diff and look for metal chunks or silver oil. Side note while your under there...
-
get the back wheels off the ground trans in neutral, spin the back wheels by hand, listen for where the clunks are coming from. i'd...
-
Shubbydog replied to the thread What type of metal is the exhaust?.I’ve welded stainless just fine with flux core and with gas welders.
-
Yeah, not sure what muffler shops but probably not actually stainless steel filler wire because their welds do rust...which is not big...
-
Look up a wiring diagram or just simply test with a test light at the light socket.
-
Shubbydog replied to the thread No spark past disturbutor/ egr solenoid and fuel pump relay click.is it spark issue or fuel issue? Did you replace your plug wires? I’ve had one of my plug wires arch to the block before from bad...
-
-
Loading…
-
Loading…
