Charlie207
Latest activity Postings About
-
-
Charlie207 replied to the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?.Reinstalled both front axles that I had been too lazy to stick in when I swapped front diffs. It's getting close to slippery road... -
Charlie207 replied to the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?.
-
-
Charlie207 replied to the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?.How is that even possible if adding LT headers - effectively letting the engine breath a ton better right off the cylinder heads -...
-
Charlie207 replied to the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?.I would just get rid of the 3rd - unmonitored - cat. Your engine will be stinky with all three removed. I assume you have a tune...
-
Charlie207 replied to the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?.Looks good. Hope that flexpipe stays sealed for years and years. Did they just weld the factory Walker clamp to the exhaust pipe, to...
-
Charlie207 reacted to mikez71's post in the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today? with
Like.
That clamp can come off and be re-used! Just stretch out the clamp tab a little with a mini screwdriver and it will pop apart with some... -
Charlie207 replied to the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?.I tried my hardest with picks and a long thin flathead, but the guts of that clamp are between the rack tube and the frame, and I just...
-
Charlie207 replied to the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?.Circled back around to install part of the steering rack stiffening kit. This metal forked wedge thing required the removal of the front...
-
-
Charlie207 replied to the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?.Replacement AutoCAL arrived today.
-
Charlie207 replied to the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?.Just cast iron manifolds. Not ready to throw $$$ at LT headers, welding in cats, and a new tune when I just got the last iteration of my...
-
Charlie207 replied to the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?.That, and the bolt and "nut" rust to shít in a year. I feel like there should be a tapered seal that fits in the normal joint to help...
-
Charlie207 replied to the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?.I have an AP muffler, and I think it may have been the same one. It definitely has less drone than the MBRP clone muffler I have...
-
Charlie207 replied to the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?.He did! He provided some links to the formula calculator that let you design your own, if you knew the variables, like engine size...
-
Charlie207 replied to the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?.So what did you go with? I'm toying with mufflers to leave the bark, but minimize drone in the SUV cabin, especially in the rear seat...
-
-
Charlie207 reacted to Doubeleive's post in the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today? with Like.
Borla XR1 Sportsman 40946, I put in on about 6 years ago
-
-
Loading…
-
Loading…
