-
-
GGilla replied to the thread Oil pan secondary valve.Geez..this is like a bad novel. Installed new oil pressure gauge/ cold start up 30psi same as factory gauge (FG). At operating temp...
-
GGilla replied to the thread Oil pan secondary valve.Found an oil cooler block off plate tapped for 1/8 NPT fitting. I'll install it later this week. Then I'll know real oil pressure.
-
GGilla replied to the thread Oil pan secondary valve.I bought the 295 HV. It should be ok? Hoping it's the gauge.
-
GGilla replied to the thread Oil pan secondary valve.Ok. It's done this from the 1st start up. I'll keep the filter #. Going to put the gauge on it. I'll let you know. What does the 3rd...
-
GGilla replied to the thread Oil pan secondary valve.I'm going to install a mechanical gauge to double check my gauge is good. Hope it's not cam bearings Replaced the o-ring again Put...
-
GAFM-DOD delete. Low oil pressure. 30 ish when cold. 10ish when warm. Everything verified. O-ring, pump spring, oil pump, 2 AC DELCO...
-
-
Loading…
-
Loading…
