992dr's latest activity
-
Not quite sure what you're asking, other than potential "known issues" or that kind of thing. The powertrain is solid. I'd even say... -
Ppv lifted
-
992dr replied to the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?.Too funny, that's what I was thinking. Thanks Oh yeah, I'm on the center caps. I didn't like the emblem in the center, it was a sticker...
-
992dr reacted to Tonyrodz's post in the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today? with
Like.
I think they look really good. I like them. Kind of looks like an exaggerated version of the GTA Trans Am rims--which I like. Very nice... -
992dr replied to the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?.Haven't been on much lately, pop in here and there. This is a momentous occasion haha I finally found a set of wheels I thought were a...
-
-
Washed both of my old turds, looking spiffy.
-
Have you tried a little test spot of glue? Usually the instant adhesive stuff dries very brittle and can/will come apart when you hit...
-
992dr replied to the thread Front Dash Crack.I haven't yet, today was crappy out. I'm going to put a dab on a section tomorrow morning. I'll let yah know how it goes. It's pretty...
-
992dr replied to the thread Aluminum / XFE NNBS Front Suspension Rebuild.Thanks again my friend
-
992dr reacted to petethepug's post in the thread Aluminum / XFE NNBS Front Suspension Rebuild with Like.
Inner tie rods on the OEM hydraulic rack are unchanged. Fortunately GM only changed the outter tie rod pitch of the taper that fits...
-
992dr replied to the thread Sooooooo, I bought a PPV ....Man, I can tell yah one thing, I sure do appreciate your photo documenting everything. Anything with wires makes me weary haha. That is...
-
992dr replied to the thread Front Dash Crack.I don't know why I didn't post this earlier, but I got this to try to keep the pieces together and from falling apart and down into the...
-
-
Good to know and thanks.
-
the only issue with a cap is if the cluster ever needs to come out you will have to pull the cap off
-
Depending how accessible the cracks are, I’d do a drill point at the end of each one then hot staple the crack itself just so it doesn’t...
