blondie70's latest activity
-
Bblondie70 reacted to Marky Dissod's post in the thread 2015 Yukon 6L80 transmission suggestions? with
Like.
Either your TCC or your transmission is on borrowed time. Really cannot hurt to change the ATF again. Have you disabled Engine Half@$$... -
Bblondie70 reacted to latvius's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Like.
Yeah and the bonus for me is when I went to buy the original doors one of the two was discontinued....thanks GM...
-
Bblondie70 reacted to mattbta's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Like.
I'm about to have to hack my daughter's 2014 Camaro up to do the same. Craptastic design by GM. If you run MAX A/C the actuator will...
-
Bblondie70 reacted to latvius's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Like.
Billet aluminum dual zone blend door install, just fyi I had a heater treater installed about 10 years ago is why the plenum is cut up...
-
Bblondie70 reacted to Tonyrodz's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Like.
-
Bblondie70 replied to the thread 1999 Gmc Yukon Electric help.Don't know what's wrong with it...but...I think I would be unhooking the battery at nite or whenever you leave it unattended. Do this...
-
BThanks! Thats a pretty good deal. I will consider this for my gen 3 rebuild. Im going to try to find the cheapest driver side valve...
-
BHere's a link to a set I bought on Amazon for my Hummer H2: Updated valve covers Quality was awesome, unbelievable for the price...
-
BIn 2018 at 130k miles when we bought our road hard and hungup wet Yukon, the piston rings were stuck from sucking & burning oil because...
-
BSome of the cam and crankshaft sensor issues like long crank times are due to the fact that a CASE relearn isn't done after one or both...
-
BLOL ... And a lot less effort than trying to press new bushings in!
-
BI've replaced the LCA/UCA bushings on my 99 Silverado and 06 2500 Suburban. They are definitely a challenge. The ball joint c-style...
-
BI agree with @rdezs . You are much better off to change the entire control arm, than to try to extract/replace worn bushings and you...
-
BDefinitely just swap out both control arms. Did the wife's Escalade a little while ago, marked where the adjusters were. Went for the...
-
BI picked up a full set on the book of faces marketplace, new in the unopened box for $300. The guy said the trans on his 19 went out...
