Forums
New posts
Search forums
What's new
New posts
New resources
Latest activity
Resources
Latest reviews
Search resources
Log in
Register
What's new
Search
Search
Search titles only
By:
Latest activity
Register
Menu
Log in
Register
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
blondie70's latest activity
B
blondie70
reacted to
rdezs's post
in the thread
2011 Tahoe/Real axle bearings Timken versus stock
with
Like
.
My 2014 all wheel drive Escalade has the 9.5 inch 14 bolt rear differential. The 8.5 in uses different bearings and seals. You might...
Jan 15, 2025
B
blondie70
reacted to
swathdiver's post
in the thread
2011 Tahoe/Real axle bearings Timken versus stock
with
Like
.
Factory bearings are Timken or Koyo. What you are seeing is a repair bearing and seal unit used when the wear surface of the axle shaft...
Jan 15, 2025
B
blondie70
reacted to
Shubbydog's post
in the thread
No spark past disturbutor/ egr solenoid and fuel pump relay click
with
Like
.
is it spark issue or fuel issue? Did you replace your plug wires? I’ve had one of my plug wires arch to the block before from bad...
Jan 15, 2025
B
blondie70
reacted to
DodDel5-3-6L80e's post
in the thread
Troubleshooting Power Door Locks
with
Like
.
My doorlock actuator wire rubbed through the shield inside of the wire loom from door jam to door. It was hard to pinpoint till it got...
Jan 15, 2025
B
blondie70
reacted to
Fless's post
in the thread
GearBox and Possible wheel hubs
with
Like
.
Your rear bearings are part of the axle assembly; they're not standalone hubs like the fronts are.
Jan 15, 2025
B
blondie70
reacted to
j91z28d1's post
in the thread
DOD delete but keep VVT?
with
Like
.
huh. yeah, that sounds low enough it's worth fixing then. so all I can add is my experience with the afm oil holes under the vlom...
Jan 15, 2025
B
blondie70
reacted to
donjetman's post
in the thread
DOD delete but keep VVT?
with
Like
.
@ckeister at 196k miles for preventative maintenance I changed my cam position sensor recently. Did NOT need a relearn. replaced valley...
Jan 15, 2025
B
blondie70
reacted to
rdezs's post
in the thread
DOD delete but keep VVT?
with
Like
.
You can plug the oil pressure relief in the pan when deleting the AFM. It's there to protect the AFM solenoids in case your pressure...
Jan 15, 2025
B
blondie70
reacted to
SpareParts's post
in the thread
DOD delete but keep VVT?
with
Like
.
Im 63YO. I sometimes feel like I'm getting too old for this shit also, But after I thought about it a few months ago, I realized I like...
Jan 15, 2025
B
blondie70
reacted to
ckeister's post
in the thread
DOD delete but keep VVT?
with
Like
.
No the mechanical guage and dash are pretty much the same at this point. Hot idle goes down to the top of the red after driving it 10...
Jan 15, 2025
B
blondie70
reacted to
donjetman's post
in the thread
DOD delete but keep VVT?
with
Like
.
This will keep ya busy: https://www.onallcylinders.com/2019/10/03/the-definitive-guide-to-ls-engine-specs-and-ls-engine-upgrades/
Jan 15, 2025
B
blondie70
reacted to
j91z28d1's post
in the thread
DOD delete but keep VVT?
with
Like
.
15 to 19 hot idle but still dip in the red on the dash? that could be a few different things. you might move the mechanical gauge up to...
Jan 15, 2025
B
blondie70
reacted to
OR VietVet's post
in the thread
Can i run my 2005 Yukon 5.3l with 8 quarts of oil in it
with
Like
.
Yes, the cluster is very easy to change out, if you have another like vehicle. Literally can disassemble both clusters and plug in to...
Jan 15, 2025
B
blondie70
reacted to
Fless's post
in the thread
Can i run my 2005 Yukon 5.3l with 8 quarts of oil in it
with
Like
.
Tough situation. But unless I'm mistaken, you did the diagnosis and the shop did the work that you requested, so I'm not quite sure how...
Jan 15, 2025
B
blondie70
reacted to
Geotrash's post
in the thread
What did you do to your NNBS GMT900 Tahoe/Yukon Today?
with
Like
.
Passed state inspection today on the '07 and I'm thankful to have an honest shop. I thought for sure I had a failing lower ball joint...
Jan 15, 2025
Forum statistics
Threads
133,256
Posts
1,882,218
Members
98,289
Latest member
Wash114
Latest posts
What did you do to your NNBS GMT900 Tahoe/Yukon Today?
Latest: Doubeleive
21 minutes ago
General Discussion
J
Removing Denali Steering Wheel Trim Ring
Latest: j91z28d1
33 minutes ago
Interior
J
Auto Fold Option on Outside Mirrors Stopped Working
Latest: j91z28d1
42 minutes ago
Exterior
RENAMED!! The adventures of Chase and his 2006 Yukon XL Denali!! Follow along on my travels!
Latest: adventurenali92
58 minutes ago
Under Construction
Rocket Man's 02 Denali Build Thread AKA "THE BEAST"
Latest: adventurenali92
Today at 1:29 AM
Under Construction
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top