Charlie207's latest activity
-
Charlie207 reacted to 2014 Tahoe LTZ's post in the thread Battery Replacement: What is required? with
Like.
UPDATE: I just wanted to thank everyone for their quick and accurate advice. A recent cold snap killed off what was left in my... -
Charlie207 replied to the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?.Did you want some photos? I realize now that the feature to change idle speed is only temporary, for diagnostic purposes, and ECU idle...
-
-
Charlie207 replied to the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?.I don't know the relevant NH-specific laws regarding readiness tests, and the paperwork just stated that the emissions test failed (but...
-
Great MacGivering! You just saved yourself a pile of money. Celebrate with another lubricant.
-
Great work!
-
Charlie207 reacted to Doubeleive's post in the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today? with Like.
Swapping power fold motors
-
Great job! You probably did a better job than what the shop would have done too.
-
Charlie207 reacted to 89Suburban's post in the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today? with Like.
It’s my understanding you have to drive about 50 miles to get the monitors to reset.
-
Charlie207 reacted to Doubeleive's post in the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today? with Like.
let it sit overnight and then take it for a 55mph cruise about 20 minutes down the highway and back and if possible take a side road...
-
Charlie207 replied to the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?.Replaced both lower ball joints, to comply with the failed safety inspection. Now I just have to wait for the EVAP system and O2 Sensor...
-
Just ordered new u joints with seal and will change differential fluid while im at it. Love this forum! Thanks swathdiver!!
-
My 2007 Tahoe 5.3
-
Per my recent yearly state safety inspection, they said the two LBJs were bad, and wanted $1,056 to replace. Not in this economy bud...
-
-
Charlie207 reacted to swathdiver's post in the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today? with Like.
Technically, the GMT900 HDs were made in 2014 as well. But I know what you mean. Just happy to have finally confirmed that the trusty...
-
That's different. Never seen a setting for it in Torque, only the Tech-2.
