latvius's latest activity
-
latvius replied to the thread What did you do to your NBS GMT800 Tahoe/Yukon Today?.My a/c blower was making a womp womp noise like a helicopter and driving me nuts. I replaced the blower and it wasn't it so I replaced... -
-
latvius reacted to mwilson62000's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with
Like.
The evap vent solenoid under the truck by the gas tank. -
latvius replied to the thread What did you do to your NBS GMT800 Tahoe/Yukon Today?.What did they replace?
-
latvius replied to the thread Rear Main Seal OEM or Felpro.Would it be possible? Maybe, would I try and find out on the rear main where you have to pull the trans again if your test fails - hell...
-
This is how I do it: I bought that tool as well.
-
latvius reacted to Kman's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Like.
Was driving to work and I heard a loud pop from the driver side rear window when I went to roll it up. Window was stuck an inch down...
-
latvius replied to the thread Front end Rebuild.Yes, correct
-
Ok sweet thanks!
-
latvius replied to the thread Front end Rebuild.Yes if you were above the truck looking down
-
latvius replied to the thread Front end Rebuild.They will still be down, the way I could envision it is I took an offset wrench and held it sideways covering one end with may hand...
-
latvius replied to the thread Front end Rebuild.Topside of the drawing shows installed wrong. Even with pictures it can be a head scratcher. The holes where the pitman arm and the...
-
-
latvius replied to the thread Front end Rebuild.Upside down, backwards, it's basically if you pulled it off and swivelled it 180 degrees, right to left and left to right of the...
-
Problem is, it WILL line up and bolt up. THEN, when you drive it, you will know something feels very wrong, but you will stare at it...
-
latvius replied to the thread Front end Rebuild.Make sure you put your new centerlink in correctly it is easy to install backwards and at 200k I wouldn't assume the current one is in...
-
latvius reacted to mattbta's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Like.
Gave this a shot on the Hoe and wife's GLE. Guess we'll see in the sun tomorrow how well it did.
