mattbta's latest activity
-
mattbta reacted to latvius's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with
Like.
Billet aluminum dual zone blend door install, just fyi I had a heater treater installed about 10 years ago is why the plenum is cut up... -
mattbta replied to the thread What did you do to your NBS GMT800 Tahoe/Yukon Today?.I'm about to have to hack my daughter's 2014 Camaro up to do the same. Craptastic design by GM. If you run MAX A/C the actuator will...
-
mattbta reacted to Tonyrodz's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Haha.
-
mattbta reacted to Tonyrodz's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Like.
I agree, especially if your state has inspections. I have the long tubes and y pipe with no cats on my 03, and the smell does get...
-
mattbta replied to the thread Reworking harness for high volume Fuel Pump.I grabbed it for a 2001 based on your site. Maybe it changed over the years? Was that the correct MY for your rig?
-
mattbta replied to the thread Reworking harness for high volume Fuel Pump.HTH,
-
mattbta replied to the thread What did you do to your NBS GMT800 Tahoe/Yukon Today?.Personally, I'd keep saving and get the catted y-pipe AND a tune. I know, opinions and all. Had an open exhaust LS1 when I was 19 and...
-
I was able to view the video. It took "a little" longer to crank, but not that bad honestly. Your next step would be to check fuel...
-
mattbta replied to the thread What did you do to your NBS GMT800 Tahoe/Yukon Today?.
-
-
mattbta reacted to strutaeng's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Like.
Yes. It's a 2k high solids clear with UV protection.
-
I. must have scrolled right by it. wow, 2008 specific. that's pretty wild. good job getting it fixed. I would have never guessed a...
-
mattbta replied to the thread p1153 even with 2 OEM o2 sensors.first post has a link
-
mattbta replied to the thread 05 Yukon/New guy.howdy from north Texas
-
mattbta reacted to strutaeng's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Like.
Finished my 6.0 LS engine I started building over 1 years ago! Installed pushrods, rockers and valve covers. L96 block with Gen III...
-
I did it! I got her home. My first Tahoe, a PPV. She's a 2014 with 150K on it. Ice cold AC BUUUT it has a Cyl #4 misfire. I swapped...
