mikez71's latest activity
-
So the Fuse you mentioned is good. I went as far as taking the entire Fuse box out and apart to inspect it all and there is no... -
mikez71 reacted to Fless's post in the thread OK, Bought a 07 with a couple problems today. with
Like.
I'd say plan to do an oil change and pull that oil pressure sender to inspect the screen. Might as well change the screen, or both it... -
mikez71 reacted to SpareParts's post in the thread OK, Bought a 07 with a couple problems today. with Like.
It is a 2007 Yukon XL Denali 1500. AWD 6.2L, 200K It has the P0011 code and hot oil pressure is about 15PSI. Known when i bought it. It...
-
mikez71 replied to the thread 07 LT 5.3L Sudden no start/crank.yep, we're on the same page. I was just more focused on the + side of the circuit, being there are more connections. Then you show up...
-
Im not really concerned with the 8v right now since it didnt happen when the key was in crank position. The 12v according to OP was...
-
mikez71 replied to the thread Escalade pulls to the left - Replaced almost everything!.Being driven in a RHD country, not something I would have ever guessed!
-
mikez71 replied to the thread 07 LT 5.3L Sudden no start/crank.Initially I thought he was measuring one terminal that went from 12V to 8V back to 12V. Now I see he has one constant 12V, and the other...
-
-
Scanner will be practically useless for this failure other than to see input and output state of BCM and PCM. Need to ohm that ground...
-
mikez71 reacted to 89Suburban's post in the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today? with Like.
Buffed
-
mikez71 reacted to Charlie207's post in the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today? with Like.
Mucked around with the rig for a couple hours while the air temps were warm. I had ordered that steering rack stiffening kit off...
-
I've tried N. Wiggling it while cranking, just took the ignition switch off and wiggled it while cranking. Stepping ******* the brake...
-
is the shift indicator showing it is in PARK?, try moving it to neutral that could be another reason for no start
-
Yes, just accessories. It jumps to 12v when the key is being turned to the crank position.
-
mikez71 replied to the thread 07 LT 5.3L Sudden no start/crank.Good luck, fingers crossed! Scanner should be able to tell you if the ignition if ECM/BCM are receiving the start signal. Should be able...
-
Thank you. I have a friend coming over tomorrow with an advanced scanner to see if it comes up with anything. I'll keep you updated and...
