mikez71's latest activity
-
mikez71 reacted to 89Suburban's post in the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today? with
Like.
It's one of the few things I hate on these rigs. I don't know the answer. I tried dielectric grease on the boots, they still rip off. I... -
If it weren't for bad luck, I wouldn't have any luck at all. Replaced the water pump on my '07 Tahoe 5.3 in April. Got a cheap one...
-
mikez71 reacted to mikeyss's post in the thread OK, Bought a 07 with a couple problems today. with Wow.
I just installed the same oil pump you've listed and my oil pressure at cold idle is 60psi, and hot idle is 35-40psi. Long story short...
-
mikez71 reacted to PatDTN's post in the thread 09 tahoe ltz hood open, stabilitrack, traction control, et al with Like.
My dash is looking like a blinking beeping Christmas tree. It started with a series of beeps but I couldn't see anything in the DIC...
-
mikez71 reacted to PatDTN's post in the thread 09 tahoe ltz hood open, stabilitrack, traction control, et al with Wow.
Yesterday I read about bad battery cables causing a host of issues just like mine. I opened the hood and started tugging on the battery...
-
Wow this was one hell of a ride, great job by everyone involved. @J-Herkel your persistence and cool head paid off, well done sir.
-
Nice job!!!
-
made sense to me but I also know what gymfaithrn means
-
Since the starter relay and the run/crank relay share the same N5 ground on the bottom of the board and the run/crank N5 seems to have...
-
should just be a few mA of current to close the relay contacts. the starter solenoid is grounded thru the block. the wire will be fine...
-
might be wise to just replace it, there is no shortage of them out there
-
Your middle pic shows a trace that has acted like a fuse because the current passing through it exceeded its rating. So that trace...
-
mikez71 replied to the thread ECM Re-flash or Replace.9 years old today! :p
-
I didn't realize the positive cable on the battery terminal was slightly loose. I tightened it up and everything is working normally
-
mikez71 reacted to j91z28d1's post in the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today? with Like.
I didn't look up the codes. but just as info, if you mean your torque converter is locking and unlocking a lot. I've heard of it being a...
