mikez71's latest activity
-
mikez71 replied to the thread SOLVED - 2014 Suburban Electrical gremlins.So you are saying your voltage now fluctuates? Is that with the current sensor plugged in or not? (It fluctuates without it plugged in... -
mikez71 reacted to bacon612's post in the thread SOLVED - 2014 Suburban Electrical gremlins with
Wow.
On a hunch, I ordered a remanufactured Bosch 2 pin 160 Amp alternator from summit racing. After installation I went for a test drive... -
mikez71 reacted to bacon612's post in the thread SOLVED - 2014 Suburban Electrical gremlins with Wow.
It couldn't be battery power alone, why would the voltage be 13.6-7? When I first disconnected the two, I hammered the electrical system...
-
Oil consumption: Install a catch can and have you or a PO installed the improved driver side valve cover per GM TSB# 10-06-01-008M...
-
I've definitely been thinking about aftermarket. I'd probably just go basic though, keep key ignition, factory fobs with 3x push to...
-
mikez71 replied to the thread Remote Start Troubleshooting.I have read, a full write with HPtuners does not write the base OS. If you had a new transmission module that had no programming...
-
All back together and working great. Gears are a bit noisy at first wearing in but now are no louder than the nylon gears. A comment...
-
mikez71 replied to the thread Warm Start stumble/multiple attempts... where to start looking?.I may have exaggerated. I only find a couple logs where it climbs to 82psi.. That was only a a 60 degree day, but the pressure does seem...
-
-
mikez71 replied to the thread Warm Start stumble/multiple attempts... where to start looking?.Yes, after shutoff the heatsoak causes it to go up. Think it's normal.
-
mikez71 replied to the thread Warm Start stumble/multiple attempts... where to start looking?.I have noticed fuel pressure rising after shutting down.. Gets upto around 100psi if engine is warmed up and you shut it down. Also...
-
-
mikez71 reacted to strutaeng's post in the thread Warm Start stumble/multiple attempts... where to start looking? with Like.
Hook up a fuel pressure gauge. It was pretty common on the older vehicles for this to happen and usually was fuel leakage into cylinders...
-
mikez71 reacted to rdezs's post in the thread Warm Start stumble/multiple attempts... where to start looking? with Like.
Definitely sounds like something we need to address with the tuner. On a side note, your coolant temperature gauge operating...
-
mikez71 reacted to Charlie207's post in the thread Warm Start stumble/multiple attempts... where to start looking? with Like.
2014 Yukon SLT 4x4 183,*** miles... 5.3 swapped to 6.0 with BBP tune, 50lb. injectors, Low Buck truck cam (truck norris clone). (I've...
-
I know I'm late to this thread but did you ever figure this out? I had the same issue, sounded just like yours and the rockers felt...
-
Cosigned. @12XLYukon, I'll add that I use a piece of glass to test my push rods. I have a ~12" round mirror hanging in the shop to see...
