mikez71's latest activity
-
mikez71 replied to the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?.Mirrors can't see around the outside corner (when turning). I was backing into an angled parking spot once, making the sharp turn, and... -
mikez71 reacted to Joseph Garcia's post in the thread Thoughts on greasable upper amd lower control arm bolts? with
Like.
IMO, greaseable ball joints are not necessary. Most ball joint failures that I've seen start with the rubber protective boot being... -
mikez71 replied to the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today?.Aftermarket running boards! I have a similar wrinkle on the right corner of the rear bumper. Proof that parking assist is useless!
-
mikez71 reacted to George B's post in the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today? with Sad.
I think we are fighting the same fight. I believe my pan is leaking too.
-
mikez71 reacted to Rocket Man's post in the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today? with Like.
Bought an 08 Tahoe LTZ today. My 02 is down for awhile and although I finally got my 08 Silverado back from the body shop, I don’t want...
-
mikez71 replied to the thread Thoughts on greasable upper amd lower control arm bolts?.Plus grease-able moogs feel like turning a rusty bolt, factory ball joints felt nice and smooth. Don't really notice it driving, but as...
-
mikez71 reacted to swathdiver's post in the thread Thoughts on greasable upper amd lower control arm bolts? with Like.
GM OE parts only. Nothing else is as enduring.
-
mikez71 reacted to Doubeleive's post in the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today? with Like.
those metal ones have been out for a minute now, i'll be dammed if I ever use one though the oem plastic ones are hard enough to get off...
-
mikez71 reacted to OR VietVet's post in the thread Avoid GM Parts Giant if at all Possible with Like.
I can't remember where, but I think I saw a GM Part's Giant warning before, somewhere. I have had good luck with GM Parts Direct
-
Just got another update from them and I’ll be getting the full refund. So the case is closed but there’s no reason it needed to be this...
-
mikez71 replied to the thread A heads up for y'all..Where is this shift torque factor setting? And what should it be set to?
-
I personally set the tranny tunes up so they don't go below a certain shift torque factor setting. There is a lot of room in the part...
-
So, is it a good idea to try to 'trick' the ecm into thinking its load is slightly higher than actual?
-
mikez71 reacted to Jooseevh's post in the thread 2008 Chevy Tahoe ppv crank not start - SOLVED with Like.
fixed it! It was the dowel pin on the cam sprocket not aligned in the hole the right way I did the timing marks right I didn’t realize...
-
mikez71 reacted to 89Suburban's post in the thread What did you do to your NNBS GMT900 Tahoe/Yukon Today? with Like.
How did you stumble across that? Cool. tag: heater tee
