NickTransmissions's latest activity
-
NickTransmissions replied to the thread GM 6L80 Transmission Information Thread.Yes, give it about 10 complete drive cycles. Computer has to relearn your driving habits, etc and that takes some time...If it's still... -
NickTransmissions replied to the thread GM 6L80 Transmission Information Thread.Bumping this thread with a video on purchasing a used 6L80 or 6L90....While I generally don't recommend buying used automatics, many...
-
NickTransmissions replied to the thread GM 6L80 Transmission Information Thread.See if you can buy one from General Motors (either directly through the dealership or via GM Parts Direct / gmpartsdirect.com). Check...
-
NickTransmissions replied to the thread 1997 Tahoe 4wd model.No upshift from first is usually caused by an interruption of the voltage signal from the vehicle speed sensor (yours is in the transfer...
-
NickTransmissions replied to the thread Transmission slams into 1st SOLVED.Yep, just a bit late, haha but glad OP worked it out :)
-
NickTransmissions replied to the thread Transmission slams into 1st SOLVED.Sounds like the stator (one-way clutch assembly) inside the converter was defective and slipping. Glad you were able to get it resolved...
-
NickTransmissions reacted to jared999's post in the thread Transmission slams into 1st SOLVED with
Like.
In case it helps someone in the future: The issue was a bad torque converter, covered under GMC warranty. Had a new one installed and... -
NickTransmissions reacted to Geotrash's post in the thread Transmission slams into 1st SOLVED with Like.
Thanks for following up with what worked!
-
NickTransmissions replied to the thread 07 Yukon transmission shifting issue.Yep, I'm based in Vegas. Where are you located?
-
NickTransmissions replied to the thread 07 Yukon transmission shifting issue.You should start a separate thread vs posting in someone else's so that you can get full attention on your issue vs competing with the...
-
NickTransmissions reacted to Fless's post in the thread Transmission output shaft seal/bearing with Like.
This is why I put the word "arguably" in that post. ;) I believe Eric O and others that say it's not necessary, based on their...
-
NickTransmissions replied to the thread Transmission output shaft seal/bearing.I made the mistake of putting the drive shaft back on w/o indexing and it let me know immediately upon driving it...Happend twice, once...
-
NickTransmissions replied to the thread Torque converter.Have them take the pan off first to make sure the transmission doesnt also need an overhaul. If fluid looks good and nothing concerning...
-
NickTransmissions replied to the thread Weird Sporadic Combined Errors - Stabilitrak, Collision Prep, P0700 P182B - SOLVED.One of your codes is related to the internal mode switch (IMS). The IMS communicates range position to the PCM and also acts as a...
-
NickTransmissions replied to the thread Transmission output shaft seal/bearing.Thanks, @OR VietVet ... Hopefully it helps @diezelraccoon with the info he's looking for...
