nonickatall's latest activity
-
the lock ring that holds the pump in the tank tend to rot out, then the pump is loose and the gas can come out the top hole. with a... -
Hello, a while ago my car started to smell of petrol every now and then. I kept checking to see if I could see anything but didn't...
-
nonickatall replied to the thread OIL PSI / BRAND / WEIGHT.Good oil is always good for the engine, but I saw the diesel thing in the YouTube video and was skeptical too. So I checked my oil...
-
Before trying any ‘home brew’ flush or additive to the oil I would use the new Valvoline Restore & Protect oil for 3-4 oil changes. Do...
-
nonickatall replied to the thread Hesitating to Start.Isn't that a little low? Should be between 55-62 PSI, so you should swap the fuel pressure regulator and fuel filter, if your Tahoe has...
-
nonickatall replied to the thread OIL PSI / BRAND / WEIGHT.At first, my truck's oil pressure was relatively low. I started by replacing the O-ring on the oil pump. That helped a little. But...
-
nonickatall replied to the thread Low Blinker Fluid?.There are cases where a poor blinker fluid level and winter air not used in winter for the tires, correlate with each other in an...
-
nonickatall replied to the thread Bank 1 and 2 lean codes.A common knowledge is, that problems which apears with cars or woman mostly not disappear from themself... :cool:
-
nonickatall replied to the thread Bank 1 and 2 lean codes.So check first the fuel pressure. There is a connection on the rail for that purpose.
-
Lean on BOTH banks is usually a fuel delivery issue, especially when both banks fuel trims are identical and stay the same (or worse)...
-
nonickatall replied to the thread P0446 after purge valve replaced.If your vent valve fails, the code pops out of the blue, because the system is only checked at certain conditions. When I remember...
-
nonickatall replied to the thread 03 z71 Tahoe didn’t stay aligned.And check the steering wheel adjustment nut. It's located near the master brake cylinder. You should loosen this, grease the rod and...
-
Thanks for the responses. My son did the majority of the work. I helped with some things here and there. Will run some of these...
-
nonickatall replied to the thread 03 z71 Tahoe didn’t stay aligned.He writes nothing about a Shop, i understand that he did it himself... So he has to fire himself? :oops: :Big Laugh:
