nonickatall's latest activity
-
Have you done any work lately that involved installing any sheet metal screws or disassembly/removal of anything hard like a valve... -
You should be able to do a direct PCM swap. The PASSLOCK is in your BCM so no problems there. There may be some accesories like AUTO AC...
-
nonickatall replied to the thread Truck won't crank.No i did very less in the last half year on my truck. Only known problem is that my fuel pump is leaking. I smell gasoline when i drive...
-
nonickatall replied to the thread Truck won't crank.I have a friend how has the same truck. Can i swap the PCM, just to check if his PCM works, or do I have to program the Key Lock system...
-
nonickatall replied to the thread Truck won't crank.@rockola1971 I disassembled today the PCM. The connector was absolutely clean, no green crust. I opened up as well the PCM and as...
-
-
Check resistance to ground at both terminals of the PCM B fuse. PCM B fuse also feeds power to some of the PCM so you may need to pull...
-
nonickatall replied to the thread Truck won't crank.I ask Chat GPT about that issue and it told me this points. So I disconnected that small plug from top of the alternator, put in a new...
-
nonickatall replied to the thread Truck won't crank.I found something. I checked all the fuses an found a blown PCM B 20A fuse. I replaced it and the truck cranked for short. The engine...
-
nonickatall replied to the thread Truck won't crank.Interesting fact is: When i had the problem first, a few weeks back. The car was driving, i stopped at the school to pick up my...
-
nonickatall replied to the thread Truck won't crank.Thank you all very much. I have 12v on the main cable of the starter and ground from the ground cable. But on the trigger wire, i have...
-
Hit this link for an electrical diagram, but you may need to change the link at the top, depending on your specific model. I suspect...
-
I 2nd an ignition fuse popped. After that I suspect ignition switch on the steering column is burnt at contacts.
-
Also, your owner's manual will have a diagram of the various electrical centers (fuseboxes) with somewhat limited descriptions of each fuse.
-
the fat cable to the starter should always be 12 v hot. the small wire should show 12 v when the key is turned to crank, its the trigger...
-
I have a problem with my truck. it won't crank. I had that problem a month ago as well a few times and I swapped the battery, after...
