OR VietVet's latest activity
-
OR VietVet reacted to 91RS's post in the thread Rough idle, lots of vibration, sluggish acceleration, shuddering at low speed with
Like.
One engine mount or both? If you only had one replaced, you are now feeling the engine vibration through the collapsed right one. -
OR VietVet replied to the thread What is the name of this joint and where can I get one?.https://www.rockauto.com/en/moreinfo.php?pk=14070777&cc=1441040&pt=11373&jsn=660
-
OR VietVet reacted to petethepug's post in the thread What is the name of this joint and where can I get one? with Like.
-
OR VietVet replied to the thread Exhaust Manifold Gaskets/Lifter Tick.If that is the case. The metal swells a little when heated and may not have a leak till it cools down again.
-
Yeah it's pretty gross, hopefully a flush will help clear out whatevers in the rest of the engine. I cannot feel the exhaust leak from...
-
OR VietVet replied to the thread Exhaust Manifold Gaskets/Lifter Tick.Looks nasty in that pan. Yea, give it a try with the cleaners and see what happens. Can you feel the exhaust leak? Does it get less or...
-
You do have a point there, only paid $3000 cash, no payments on it. Hopefully the lifters can be a 20 minute job ;) Going to run...
-
OR VietVet reacted to j91z28d1's post in the thread Rough idle, lots of vibration, sluggish acceleration, shuddering at low speed with Like.
if I had to guess I'd say the dealer messed up your driveshift. I'd take it back and have them test drive it.
-
OR VietVet replied to the thread Exhaust Manifold Gaskets/Lifter Tick.The pitting will be taken care of with the copper RTV. Slight pitting would have to be bad right at the gasket sealing area, from side...
-
OR VietVet replied to the thread Exhaust Manifold Gaskets/Lifter Tick.If it is in fact leaking because of a warped flange, it will get worse.
-
Yeah I didn't even really think about it to be honest. The leaks are tinyyy, I mean a very small section. Not even enough to cause a...
-
OR VietVet replied to the thread Exhaust Manifold Gaskets/Lifter Tick.Like @Scottydoggs and @Marky Dissod suspect, I too suspect the manifold flange surface. In the beginning, you did not say the manifolds...
-
OR VietVet reacted to Marky Dissod's post in the thread Exhaust Manifold Gaskets/Lifter Tick with Like.
If you've replaced the gaskets and you STILL have a leak, it's likely there's a surface that needs to be smoothed true.
-
OR VietVet reacted to Scottydoggs's post in the thread Exhaust Manifold Gaskets/Lifter Tick with Like.
you could run a straight edge over the flange to check. china made stuff is not always so good.
-
they didn't look cracked or warped, they are brand new, although cheaper ebay ones. The leaks are very very small.
