RAMurphy's latest activity
-
RAMurphy reacted to RoadTrip's post in the thread Back after a hiatus: 2018 Denali Build Thread with
Like.
Welcome back. The new ride is nice! -
RAMurphy replied to the thread My From Start to Finish 6.0L Build.Thank you. Yep, I was very careful of all the clearance. I even placed double layered heavy duty cardboard in front of the radiator just...
-
Excellent work. Watch the top hard lines on the steering rack. I seen them get hit and damaged during this process.
-
RAMurphy replied to the thread My From Start to Finish 6.0L Build.Then lift the engine out. Ensuring clearance on both sides as you lift the engine out of the engine bay
-
-
RAMurphy replied to the thread My From Start to Finish 6.0L Build.Pulled out and unfolded my engine hoist and attached it to the lifting plate
-
-
RAMurphy replied to the thread My From Start to Finish 6.0L Build.Onto the valley cover. Removed the knock sensor harness, knock sensors and the valley cover. Installed Lifting Plate
-
-
RAMurphy replied to the thread My From Start to Finish 6.0L Build.Attached the three claws onto the balancer The Harmonic Balancer came off pretty easily with this tool. You can see it started to pull away
-
-
RAMurphy replied to the thread My From Start to Finish 6.0L Build.Well today I got the engine out. What I accomplished today with some more pictures: Removed harmonic balancer bolt. Removed harmonic...
-
-
My son and I installed the intake today. We were not the first people in there, the harness was already disconnected from the back of...
-
My son and I went for a bit of a road trip to buy a GPI ported 6.2L intake and TB today, just over 400 miles round trip. Turns out the...
-
Welcome neighbor... Great introduction and thanks for giving the history on the vehicle. It's always good to hear these stories :)
-
RAMurphy replied to the thread New 07 Burb Member Houston.You mixed that up -it's Go Navy Beat Army! :)
-
Go Army Beat Navy!!! Welcome from FL!
-
Welcome from Miami&NYC Greg!
-
Welcome from the Centennial State!
