RAMurphy's latest activity
-
Let us know what you find/ figure out. I'm betting that your rig holds 8 quarts and something else is going on. Be pretty weird for just... -
Something just crossed my mind on this. When you "dip the stick" are you going to the fully seated position or are you just "dipping"...
-
I agree with Fondupot above about the dipstick. What makes you think that a dipstick is the ultimate word on this? Things can and do...
-
The capacity of these motors is not subject to opinion. The spec is 8 quarts that’s what goes in. I would not continue to overfill the...
-
RAMurphy replied to the thread My From Start to Finish 6.0L Build.That is what both of my build book also states. Like I said, I’m going conservative. When I started this venture and working with Texas...
-
My engine booklet says first one at 500 miles then again at 5K then I can switch over to full synthetic after that.
-
Welcome to the forum from NJ
-
RAMurphy replied to the thread Greetings from north central Indiana!.Class of 85 :)
-
RAMurphy reacted to jaywestfall's post in the thread Greetings from north central Indiana! with
Like.
Purdue Class of 84 :) -
RAMurphy replied to the thread My From Start to Finish 6.0L Build.They are Evil Energy AN6 Hoses, fittings and hose clamps. I will say the AN6 hose was a tight fit but I made it work - just took a bit...
-
Do you have a link for those hoses and fittings you used on that catch can setup?
-
RAMurphy replied to the thread My From Start to Finish 6.0L Build.I will be taking a conservative approach to my break in. You are correct no WOT during initial break in. I plan to change the oil in a...
-
Very nice! Remember to break it in properly! Is WOT pulls something that should be done during break in? I am asking because I am...
-
RAMurphy replied to the thread My From Start to Finish 6.0L Build.You are correct and I will update after break in and final tune from Black Bear.:)
-
Well done! Time to update your sig :p
