rdezs's latest activity
-
Rrdezs replied to the thread Crossmember question..By the way, pick up one of the pickup tube girdles that allows you to use two bolts securing the pickup tube to the oil pump. LS...
-
Rrdezs replied to the thread Crossmember question..You can do it on ramps, but there's more room to work if you use jack stands instead. You won't have any alignment issues reinstalling it.
-
Rrdezs replied to the thread New hydroboost to master cylinder question.I'd make sure the hydroboost and the master cylinder are both the correct part numbers for the application.
-
Rrdezs replied to the thread Heater Core Connector Tee, Which Size?.You can carefully cut that plastic collar off the hose, and replace the hoses themselves... . But with the reasonable price of the...
-
-
Rrdezs replied to the thread 2011 Yukon XL Transmission Slip.I think it's time for a quality reman. And after flushing out the transmission coolers, install one of these:
-
-
Rrdezs replied to the thread New hydroboost to master cylinder question.A common issue with dragging brakes originates with the OEM flexible brake lines to the calipers. They're rubber, and they start...
-
Rrdezs replied to the thread New hydroboost to master cylinder question.Double check your part numbers for the application.
-
Rrdezs replied to the thread lifter info.
-
-
Rrdezs replied to the thread lifter info.I've had zero issues on the lS engines I've built, using the Delphi LS7 lifters. Identified by the gold color retaining clip in the end...
-
Rrdezs replied to the thread Motor flush.As previously mentioned, a properly maintained engine will not need a flush. That means running full synthetic oil and keep it up on oil...
-
Rrdezs replied to the thread Exhaust Manifold Leak (Suspected): Tips, Suggestions, Experience?.Just a note on the types of metals and bolts.... Whether it's 90,000 or 180,000 tencil strength, there's a lot more to it than that...
-
Rrdezs replied to the thread Thud type noise when downshifting to first.How does the transmission fluid look? Anything in the bottom of the pan? Front differential mounts at three points. The rear mount is...
-
Rrdezs replied to the thread 07 denali oil pan gasket,pickup o-ring.Saved yourself an ungodly amount of cash by doing it yourself :-) It's a little late to ask, but did you get the pickup tube girdle...
-
Rrdezs replied to the thread 2007 Yukon Denali Intermittent Crank No Start.Bad ground connections on these vehicles create all sorts of havoc. I suspect it has to do with the electricity searching through other...
-
Rrdezs replied to the thread OK, Bought a 07 with a couple problems today..Same with your tie rod ends. Measure precisely...
-
