Scottydoggs's latest activity
-
Scottydoggs replied to the thread Transmission tune.theres a program called the "blue cat trans tuning tool" its a free dl, theres vids on yt to see how it works. and i for one have used... -
Scottydoggs replied to the thread Loss of fuel.cool system you got there for the lpg, id agree, its got to be a line leaking, theres a number of hoses up top with quick disconnects, o...
-
Scottydoggs replied to the thread Loss of fuel.when you say lpg, thats a propane conversion right? uses a different tank and lines to the engine? if so, you could have a bad line...
-
Scottydoggs replied to the thread Loss of fuel.the lock ring that holds the pump in the tank tend to rot out, then the pump is loose and the gas can come out the top hole. with a...
-
Scottydoggs reacted to Tonyrodz's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with
Haha.
-
Scottydoggs replied to the thread Driver's rear exh man. bolt.if you take the wheel and wheel well liner off you get a lot more room to work in through the wheel well. if theres a nub left you can...
-
-
Scottydoggs replied to the thread What did you do to your NBS GMT800 Tahoe/Yukon Today?.scan it before you turn it off after it acts up. might have a pending code waiting to fail a test a couple more times. shutting the...
-
Get under it when the exhaust is cool and start hand-shaking pipes and metal shields. Tap the catalytic converters lightly with a...
-
Scottydoggs replied to the thread Yet another EVAP thread.when filling up and the pump keeps clicking off like the tank is full, is 99% of the time a clogged up canister and lines to and from...
-
Scottydoggs replied to the thread What did you do to your NBS GMT800 Tahoe/Yukon Today?.try making a one man bleeder set up. its how i bleed brakes when im alone.
-
Scottydoggs reacted to Fless's post in the thread Brake light and no traction control light on with service brake system and stability sys disabled 2004 GMC Yukon XL 5.3 with Like.
You need a scanner that can read them; they're not standard OBD codes that the inexpensive code readers only read. If there's a light...
-
Scottydoggs replied to the thread Exhaust manifold to collector gasket.rtv for the win... guess the flanges are not warped. another win.
-
Scottydoggs reacted to NO4NSHIT's post in the thread Exhaust manifold to collector gasket with Like.
I tried the stainless and said screw it used some ultra copper exhaust gasket maker and it sealed it up perfectly
-
Scottydoggs replied to the thread Exhaust manifold to collector gasket.stainless is better, but its rough to work with being how hard it is. i was assuming you would only be using the diy gaskets temporarily.
-
Scottydoggs replied to the thread Exhaust manifold to collector gasket.might need two of the 1/16th metal. dont bother with the al.
