Stonefort's latest activity
-
Couple random pictures: Started swapping parts from the engine I pulled to the built engine. The painted AC bracket. -
Removed torque converter. That SOB is heavy. Going to wait until my son in-law comes over on Wednesday before installing the new one.
-
Spent most of the day through late this morning with our daughter and granddaughters. We will see them and the rest of our family during...
-
Then lift the engine out. Ensuring clearance on both sides as you lift the engine out of the engine bay
-
Onto the valley cover. Removed the knock sensor harness, knock sensors and the valley cover. Installed Lifting Plate
-
Attached the three claws onto the balancer The Harmonic Balancer came off pretty easily with this tool. You can see it started to pull away
-
Well today I got the engine out. What I accomplished today with some more pictures: Removed harmonic balancer bolt. Removed harmonic...
-
Took a few minutes to find a remove the single 10 mm bolt which secures the plastic wiring support located in front of the oil pan and...
-
I just removed the compressor and supported it. The compressor will remain in the engine bay along with power steer pump/
-
Wednesday was pretty productive. This is what I accomplished: Removed passenger side exhaust manifold. Disconnect water temp sensor...
-
Looked very clean after removing the intake manifold. However, a little more oil out of the passenger side breather hose - may need to...
-
I always try to take pictures before disassembly. I used to think I'd remember where something went--but I usually forgot lol.
-
You likely already have an "organization" method. I recently did an engine replacement for my neighbor across the street, on his 2006...
-
Got started a little later than I wanted - long week at work, slept in for a change. Did not get as far as I wanted, but my better half...
-
Just finished your entire thread, start to finish Bob. First, sorry for your losses with your furries (sounds weird saying that...
