strutaeng's latest activity
-
strutaeng replied to the thread Greetings and Salutations from East Texas..Welcome from another fellow Texan! This is a very good forum and lots of knowledge sharing here. Very nice truck! What are your plans... -
strutaeng reacted to 1stRC's post in the thread Greetings and Salutations from East Texas. with
Like.
Howdy from East Texas. I've recently picked up this 2006 Tahoe PPV Z56. It's originally a Fulton, Georgia Police unit. It's got... -
Gotta teach them young. Also it's great that a girl learns some stuff--instead of having to depend on a man.
-
strutaeng replied to the thread Motor Oil Brand vs Pressure?.I can't imagine why it would be the oil brand. They are supposed to produce the oil to a specified viscosity. Are you using the same...
-
Absolutely. She even helped with my transmission line fittings.
-
strutaeng reacted to S33k3r's post in the thread 2004 Silverado 2500 Quadrasteer --> Quadramax Build Thread with Like.
Got my 2007 back from the builder last week! Got it inspected, registered, and am waiting on the registration paperwork in the mail...
-
strutaeng replied to the thread My From Start to Finish 6.0L Build.Picture of little hands helping: Priceless!
-
New torque converter installed. Went right in with three obvious "clunks". Measured after to verify correct installation. It helped with...
-
Nice Job buddy.
-
strutaeng reacted to NoReverseYukon's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Like.
I even tried this un-gently. No-go. She was a stubborn cuss. I got all the parts inside now warming up before putting it all back...
-
strutaeng reacted to NoReverseYukon's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Like.
I was just trying to remove the knuckle, so all this BS was to get the tapered shaft of said ball joint out of the LCA. And even though...
-
strutaeng reacted to clandr1's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Like.
Was this your first time? If so, did you grind down the retaining tabs before you started whacking the BJ? Also, as my dad always...
-
strutaeng replied to the thread What did you do to your NBS GMT800 Tahoe/Yukon Today?.Have you tried gently lifting the BJ stud (thread the nut so you don't mess up the threads) with a jack? You are essentially using the...
-
strutaeng reacted to NoReverseYukon's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Wow.
Getting that ball joint out of the lower control arm was quite the ordeal.
-
Please refer to this thread: https://www.tahoeyukonforum.com/threads/help-me-here-please.151620/
