2015 Tahoe LTZ instrument cluster ground location?

I’m having an issue with my 2015 Tahoe LTZ. The cluster is going crazy giving me tons of error messages and also the gauges going in and out. Seems to me like 90% it’s a ground issue, no way all these things failed at once.

Anyone know where the ground location is for the instrument cluster? I did search online didn’t find it.

Having the same issue here, any insight would be wonderful. 2016 LT. Gauges randomly all go to zero and then pop back up leaving “service” messages on the dash. I checked and cleaned what grounds i could find but no luck so far

So this issue was intermittent then now it totally Grenaded my car. Can’t even start it anymore electrical problems like crazy.

I checked 3 grounds and cleaned multiple connectors. There is a ground in the top left of the dash(right by the driver a-pillar) and I also checked the firewall, engine block, and chassis grounds. All were good. Also battery and alternator was tested good.


I’m leaning toward a bad BCM now. The car is totally bricked.

G218

ReaperHWK said:

So this issue was intermittent then now it totally Grenaded my car. Can’t even start it anymore electrical problems like crazy.

I checked 3 grounds and cleaned multiple connectors. There is a ground in the top left of the dash(right by the driver a-pillar) and I also checked the firewall, engine block, and chassis grounds. All were good. Also battery and alternator was tested good.


I’m leaning toward a bad BCM now. The car is totally bricked.

Click to expand...

Did you ever figure out what the issue was? I'm having a similar issue with a 2015 z71, cluster gauges go nuts for the first two minutes along with codes going off but then everything goes back to normal. New battery, new battery cables, tried a new BCM, New cluster, nothing works. Dealer can't seem to figure it out either. Any forum wisdom on the matter. ECM?

bdwood said:

Did you ever figure out what the issue was? I'm having a similar issue with a 2015 z71, cluster gauges go nuts for the first two minutes along with codes going off but then everything goes back to normal. New battery, new battery cables, tried a new BCM, New cluster, nothing works. Dealer can't seem to figure it out either. Any forum wisdom on the matter. ECM?

Click to expand...

Do you have any stored or history codes?

ReaperHWK said:

So this issue was intermittent then now it totally Grenaded my car. Can’t even start it anymore electrical problems like crazy.

I checked 3 grounds and cleaned multiple connectors. There is a ground in the top left of the dash(right by the driver a-pillar) and I also checked the firewall, engine block, and chassis grounds. All were good. Also battery and alternator was tested good.


I’m leaning toward a bad BCM now. The car is totally bricked.

Click to expand...

Are you also storing any history codes?

bdwood said:

Did you ever figure out what the issue was? I'm having a similar issue with a 2015 z71, cluster gauges go nuts for the first two minutes along with codes going off but then everything goes back to normal. New battery, new battery cables, tried a new BCM, New cluster, nothing works. Dealer can't seem to figure it out either. Any forum wisdom on the matter. ECM?

Click to expand...

Yes I fixed it. I didn’t buy a new BCM the issue was actually a bad side detection module that was corrupting the canbus on the car and causing the BCM to go haywire. It was intermittent as well. But the side detection module has stored codes for com faults so I knew something was up there.

The best way to troubleshoot this like I did is to get a good scanner and scan all your modules. Any that pop up with any codes I’d disconnect it and see if the problem goes away. Do that one module at a time. That’s what I did and once the side detection module was unplugged the truck runs fine. Hope that helps.

And sometimes other modules will "tell" on the defective module with a "no comm" code. Look for commonality.

BlaineBug said:

Do you have any stored or history codes?

Click to expand...

Just the codes relating to tire pressure, side traffic sensors. Dealer tested and all are fine. Initially all cluster gauges are wacky, turn signal not working, break light is still on, and gear light on cluster does not show the right gear. Car still runs fine and cluster if OK after 2-3 minutes.