21DenaliXL
TYF Newbie
- Joined
- Oct 18, 2024
- Posts
- 5
- Reaction score
- 4
Taking off pinstripes?
- Thread starter 21DenaliXL
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
The truck is a 2021 ? My personal opinion is I don’t think the truck has seen enough time in the sun to cause UV fading/ discoloration with a modern triple stage paint job, and even if there was, it would probably be so faint it would not be noticeable.
But, you’re concerned, the best bet is to remove a tiny slice at one of the ends to see if there is a difference. Might be hard to tell but that’s a good thing.
But, you’re concerned, the best bet is to remove a tiny slice at one of the ends to see if there is a difference. Might be hard to tell but that’s a good thing.
KMeloney
Full Access Member
- Joined
- May 2, 2009
- Posts
- 2,742
- Reaction score
- 258
No, you're not going to see any difference -- especially after a good polishing and a few days in the sun.
KMeloney
Full Access Member
- Joined
- May 2, 2009
- Posts
- 2,742
- Reaction score
- 258
Hey, I see you swapped out the chrome trim pieces around the foglight. Can you tell me how you got the stock ones off? Did you swap them when you had the whole front off the truck? I'm looking to swap mine out without removing the front end/grille and without breaking the tabs of the stock pieces.
Any advice towards doing this (maybe from under the truck) would be a big help.
tooleyondeck
Full Access Member
Super easy job. Get a 3M rubber wheel (about $50) and as @PPV_2018 said, a good polishing afterwards and you'll be good to go.
Similar threads
