Jocko PDX
Full Access Member
Someone put a door ding in my 2023 Yukon Denali. It is not that big smaller than a dime, but it is kind od deep, as if the door that hit it had a point.. Can this be fixed inexpensively?
door ding removal
- Thread starter Jocko PDX
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
perhaps free if your insurance covers PDR
by the way the metal on these new trucks is thinner, get used to it.
OP
OP
Jocko PDX
Full Access Member
How do they remove them?
Stbentoak
Full Access Member
- Joined
- Jul 20, 2020
- Posts
- 1,771
- Reaction score
- 2,057
Well, they don't actually "bang" it out from the back, they use a series of sharp pointed hooks that work the metal out back to flat. They also actually heat it with a butane torch to get the metal Pretty warm so it's easily workable. It does not harm your paint, and it really is the method of choice for dings that haven't hurt the paint.
KMeloney
Full Access Member
- Joined
- May 2, 2009
- Posts
- 3,060
- Reaction score
- 408
Have a picture of it (that also shows where in the door it is)?
I had one fixed in the front fender, very close to where it met the leading edge of the driver's door. The PDR guy (who is known to be amazing around here) wouldn't make any promises to me after only seeing pictures of the ding, but he went ahead and took care of it like it never existed.
I had one fixed in the front fender, very close to where it met the leading edge of the driver's door. The PDR guy (who is known to be amazing around here) wouldn't make any promises to me after only seeing pictures of the ding, but he went ahead and took care of it like it never existed.
Tonyrodz
Resident Resident
Depending on the location and access to the ding, sometimes the PDR guys will have to drill a hole so they can get their tools to reach the ding.
CMoore711
Full Access Member
- Joined
- Jul 18, 2017
- Posts
- 1,321
- Reaction score
- 1,157
Sometimes they just use a plunger. Suction cup that thin a$$ metal and pull that thing out!
Or hot melt glue to affix a piece of metal to pull on the sheet metal.
homesick
Full Access Member
- Joined
- Sep 19, 2018
- Posts
- 1,505
- Reaction score
- 3,960
I saw a tool that welds a rivet looking pin into the ding. Then you use the slide hammer to pop it out. Like in your example though, it leaves some need for bondo.
joe
