Search results
-
Steelcraft Brush Guard
Installed a Steelcraft brush guard today. Haven’t seen anyone else post about them so thought I would share . Overall was pretty easy, but it did take me around 5 hours. Would be much faster if you have a second person. My install was also slower because I had to remove a rough country bull bar... -
2019 Tahoe/On board air ARB air compressor
Tonight I installed the ARB CKMA12 air compressor in the extra battery tray under the hood of my 2019 Tahoe. The install was super easy and the compressor fits very nicely. It is hardwired directly to the battery and is connected to my auxbeam blue tooth switch board so the compressor can be...- Tahoe_Rx
- Thread
- air compressor on board air
- Replies: 9
- Forum: General Discussion
-
Auxbeam 8 gang switch panel
I recently installed a bull bar with 20” light bar and was hesitant to install another single switch in my cab. I ended up decided to install the auxbeam 8 gang RGB switch panel. Now I won’t have to pass anymore wires through the firewall for future accessories, everything can be wired to switch...- Tahoe_Rx
- Thread
- Replies: 0
- Forum: Audio & Electronics
-
Rough country bull bar
I searched and didn’t see anyone else with this so just posting do anyone who may be curious. I installed the rough country bull bar with 20” light bar. Super easy install. It did interfere with the two middle parking sensors but it was very easy to relocate them into the bull bar. The... -
Removed factory running board
I removed the factory running board just to see how it would look. What do y’all think? Do you prefer with or without? -
LED turn signals
Upgraded the front turn signal bulbs with LEDs from lasfit. It is incredible how much brighter they are. Photo shows LED on driver side and OEM halogen on the passenger side. -
Raptor style grill lights
I have been going back and forth on whether or not to install “raptor” lights in my ‘19 Tahoe and finally did it. I wasn’t sure if I would like it or not so I just bought cheap $10 lights on Amazon and if I like the look I will replace them with nicer lights once these inevitably go bad. The... -
Install 4 rigid industries d series lights in place of factory fog lights
Hi All, I have searched through the forum and have not seen many posts about this. I have ordered mounting brackets from KD Fabworks to replace the factory fog housings on my 2019 Tahoe LT. The brackets allow you to install ether 2 rigid industries d series lights per side or 2 Baja designs...
