Search results

  1. B

    NBS led tail lights for trucks...new in box never used...

    would you ship to edmonton? I may be interested.
  2. B

    05nali's HOW TO Ipod/AUX hookup for 03+ XM equipped trucks

    I used the mentioned 5pin "switch" style aux connector from radio shack. I don't have any pics or the schematic right off hand but mine is xm/aux audio with no patch cord plugged in, then as soon as you plug in your cord it breaks the circuit and adds the new circuit being your phone, ipod, etc...
  3. B

    Is a TDC procedure necessary?

    Usually its recommended to torque the rocker arms down while each cylinder is at a point where there is no load on the rockers or valvetrain.(TDC or any point the valves are closed) This eliminates any chance of the threads being pulled out of the head while torquing down opposed to torquing...
  4. B

    p0440 code

    If your getting excessive pressure releasing when removing the gas cap then the most likely issue is the evap canister is plugging off. If you have already replaced every other part in the system you may as well replace the canister and be done with it. Clear the code and you should be good to...
  5. B

    Steering Position Sensor

    The steering position sensor is a relative easy swap out. Basically you just have to disconnect the upper section of the intermediate steering shaft and slide it off the steering column. Obviously you have to make sure you do not turn your steering wheel at this point to avoid potential SIR coil...
  6. B

    Which O2 sensor is for my yukon

    Yeah that's right. The engine will either rev up or stall out a bit depending what product you use. Either way your looking for a change in idle speed based on introducing an un-metered foreign fuel to the mix.
  7. B

    MESSAGE "Service Tire Monitoring"

    If you can't monitor the pressures in the DIC you will have to have it scanned, it should have a history code for which sensor is intermittently reading low.
  8. B

    MESSAGE "Service Tire Monitoring"

    when the message comes up in the dic, cycle through to where it shows the pressures, one of them will probably be reading (---psi). whichever one has no reading is intermittent and will have to be changed.
  9. B

    Which O2 sensor is for my yukon

    If both banks are reading lean it may not be both o2 sensors. Could be a vac leak or intake gaskets, etc. If you want to replace the sensors the section that goes into the exhaust doesn't really matter, only the proper connectors really matter.
  10. B

    Fault Code P0300

    those plugs definitely indicate an issue on one bank only. the 4 plugs being clean and a light brown would be burning perfectly, the other bank are dark and sooty appearing which screams too rich on that bank. Intake gaskets can do some weird drivability concerns, but they will usually affect...
  11. B

    04 Yukon no heat while in motion

    sounds like he is refering to the backlighting in the hvac control head. To me it sounds a lot more like a base cooling system issue. It doesnt really make sense for the doors to change position when driving vs sitting idling to create the difference.Can try switching off auto mode and see if...
  12. B

    New from Canada

    Hey guys, new guy here from Edmonton area. Picked up a 06 Tahoe a few months ago, just looking around for some ideas and info on mods. My unit is mostly stock right now with exception of a few small things. Plan to bolt on a few things here and there, maybe a tune over the summer.

Forum statistics

Threads
132,160
Posts
1,863,293
Members
96,666
Latest member
travishunter2016

Latest posts

Top