Search results

  1. R

    c pillar removal

    thanks for the pointers, I got it off. 7mm bolt above seatbelt. Then unbolt seatbelt at the bottom by door opening. Then pry trim and it comes off in one piece (from headliner to door sill). It overlaps the quarter panel so with c pillar and d pillar removed, quarter panel trim can be pulled...
  2. R

    c pillar removal

    are the two pieces your referring to (light and dark) the lower part that has the folding seat switch and the upper part that goes to the headliner? Just pull on those two pieces once the upper bolt is removed and they'll come off together? The power seat switch is mounted to the trim piece...
  3. R

    Engine bay to cab

    I saw a previous post where someone pulled off the tape around the rubber boot and main wires. They used needle nose pliers to stretch open rubber boot and pushed wire through, Then re-taped. Not sure if that is any better than cutting a hole in the boot but looked to be water tight.
  4. R

    c pillar removal

    i'm trying to get the rear panel off where the jack is. I'm mounting my amp back there. I have the d pillar off and looks like the c pillar also overlaps the rear panel. I have '13 LTZ with power folding seats. Do I just remove the bolt above the seatbelt on c pillar and pop off the trim...
  5. R

    SB-GM-TAHOCNSL/10W1v3

    you have this model SB-GM-TAHOCNSL/10W1v3? It should fit with rear AC controls. If you have the AC vents in rear then that is the problem.
  6. R

    center dash speaker w/ aftermarket stereo?

    For those that installed new headunit, speakers and amp, did you just eliminate the center dash speaker and rear speakers in the cargo area? I'm using my RCA outs from Pioneer head unit to amp and I was thinking I could also use the pioneer speaker wire outs to hook up some infiniti 3 1/2"...
  7. R

    arc audio amp question

    Are you just tapping into the stock speaker wiring or are you running all new speaker wire from amp to doors? I really don't want to mess with getting wire through the molex plugs and am hoping I could just run 16G from arc amp to stock bose amp location and tap into the speaker wires there...
  8. R

    Sub enclosure Ideas ?!

    You must have been the one that beat me out of ebay bid so i had to buy new.... I'm going to be installing mine soon. Good to know install is easy. Did you have to sound deaden or foam the console area to avoid rattles?
  9. R

    arc audio amp question

    thank you!
  10. R

    arc audio amp question

    I'm getting Jl stealthbox for 2013 Tahoe. I was going to add arc audio 5 channel amp since i'm also replacing door speakers. I see good reviews on arc audio and the size is good to go behind panel in jack compartment The stealthbox spec mention 300 watt power handling. Wired for 2 ohm mono...

Forum statistics

Threads
132,220
Posts
1,864,241
Members
96,756
Latest member
Theopensea

Latest posts

Top