I have the same project coming up. Would taking some sand paper to the outside of the bushing help? Sand away the outside diameter of it?
Sent from my iPhone using Tapatalk
At a minimum I believe you’ll need it tuned. You should probably have a larger exhaust too, I think you’d want the 3”, where the 5.3 has 2-3/4 I think. Hopefully somebody else has more detail to my limited knowledge.
Sent from my iPhone using Tapatalk
My son calls my suburban the busburban, so I naturally named it. I thought I was in good shape b/c I de-badged the rear gate, but those letters are smaller. So I need two of the chrome B’s to finish my project from the doors. They are 1” tall, and the letters from the rear gate (that I do t...
I have the same kit from Tony. Love it so far! I currently have it set up as 2/3, but I’m having issues with my rear air shocks. The system is leaking somewhere so the compressor cycles a lot. I think it’s the compressor. Anyhow, I think I’m going to get another set of spacers to make it a 2/2...
How will re-locating the sway bar help? It doesn't change the routing of the brake cable or shock location....... does it?
Sent from my iPhone using Tapatalk
Why does my compressor purge often? When I turn the key on, the compressor runs for s minute or so to level, then I hear the compressor purge it's air and the compressor starts again. It just cycles like that over and over. Under pressure there is no leak except through the compressor vent, it...
Installed the kit. Love it. I'm having a problem with the drivers side rear e brake line rubbing on my new Arnott air shocks. I've routed the line both in front of and in back of the shock and it rubs the air bag both sides. What have you done to correct this?
Sent from my iPhone using Tapatalk
I just looked on an 09 ltz with black non auto steps, and it doesn't have this. Maybe it's the computer for the steps? Sure has a lot of wires for that.... I may have to just unplug it and see if anything else breaks.
Sent from my iPhone using Tapatalk
New to me 08 LTZ suburban, love it. I took off the power steps b/c they weren't working and I don't want them. The module in the picture was mounted to a housing on the driver side step. Does anybody know what it is, or how I go about mouthing it to the vehicle without my power step? There must...
Hmm, goofy situation. Be sure you have wires going to the seats in the first place. If so, you may have an issue with the overload circuit which I don't think is very common. If it were me, I would just order one new seat set and try replacing.
Sent from my iPhone using Tapatalk
Is there a write up on changing the elements, it is it self explanatory once the seat is out of the car? I have elements in hand, just haven't seen a write up, can't find a video, it's not in my manual, nothing.
Sent from my iPhone using Tapatalk
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.