2" front lift. Still rubbing

[Gelein83]

Installed the rough country 2" front leveling kit. Still runs tho. Guess I need to cut a little. I don't want water getting all up in the engine compartment though. The rain is bad in Oklahoma. Anyone know any good ways to keep from rubbing without having holes in the wells?

 

[Gelein83]

Oh. 295/25/28's by the way. Wheels are 34" tall.

 

[al2fast]

I trimmed mine and retained the liners fully intact. Used a heat gun to reshape. Ive only got 33" tires on 20x9 with 0mm offset. Where are you rubbing?

 

[Gelein83]

I trimmed mine and retained the liners fully intact. Used a heat gun to reshape. Ive only got 33" tires on 20x9 with 0mm offset. Where are you rubbing?

It's rubbing mostly in the bottom front of the wheel wells. Even with the 2" front lift. I need to figure out how to move them farther forward without cutting holes. I don't want it to be ghetto rigged.

 

[Jonah52]

Smaller wheels. Bigger lift (with drop down bracket). If you cut the liner there's a good chance water will get in much easier.

 

[Jonah52]

Or cut up the bumper

 

[01Konvict]

Can trim the fender liner and do it right not looking ghetto but need bigger lift to clear 34" tires.

 

[Jonah52]

Like a 6" or the lift wade has

 

[Gelein83]

I don't want it lifted more. It looks good where it is. I guess I'll try to heat gun method. It doesn't seem to need a whole lot more clearance.

 

[Juiceman74]

Just wanted to say this is a really clean ride