Chetrick87
Full Access Member
- Joined
- Apr 6, 2016
- Posts
- 166
- Reaction score
- 19
Im in the process of installing my new pioneer avic 8200 nex. Where do i hook the pink car speed signal input to? It has gps so im assuming thats why i need it
Car speed signal input
- Thread starter Chetrick87
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
OP
OP
Chetrick87
Full Access Member
- Joined
- Apr 6, 2016
- Posts
- 166
- Reaction score
- 19
I believe i have it narrowed down. I connected it to the blue/pink wire coming off of my gmos lan2 . Hopefully thats correct
Meccanoble
Full Access Member
When I spoke to a fellow installer that is knowledgeable, he made it seem like that wasnt necessary but I have the 4200nex that doesnt have gps
OP
OP
Chetrick87
Full Access Member
- Joined
- Apr 6, 2016
- Posts
- 166
- Reaction score
- 19
Well i hooked it uo to the wire coming off of the interface and all is good with that. Once i put it back in my turn signals stopped clicking. A wire must have came off of the rekay because it worked before i switched to the newer pioneer. And my rear entertainment isnt working. I mustve plugged it into the wrong soot because that was working on my old pioneer as well. I have to take it all back out Its such a pain in the ass tucking alk the wires so it fits
