Injector

[Uderro1]

Ok, going to be tackling injector replacement soon cause I got a dead hole. I know I'll need a plenum gasket and intake gasket. Is there anything else?

 

[19Yukon97]

That should be it. Make sure to plug all the intake holes with a paper towel or something and clean the crap out of the injector area. and be careful putting it back together. I did this project about 6 months ago... took me and my dad about 6 hours total to do it. Could have done it in like 1 hour with all the experience with engine building. but we were just messing around and checking other things along the way and talking about school, work, girls, etc...

 

[Uderro1]

Thanks. I never messed around with these port injected. Carbureted and fuel injection but these in betweens scary me lol.

 

[99'Yukon]

Take care when routing the new injector lines, they can be pretty stiff. Also, watch out when taking the two fuel lines out of the top of the old assembly. I didn't realize that when i was going to put them back into the new assembly that i had bent them when disassembling.

 

[SunlitComet]

well if you are going to take of the whole intake you will need at least one valve cover gasket.

 

[Uderro1]

I want to remove and replace as minimal and possible.

 

[Uderro1]

Another question. Is the spider the only one that I can put in?

 

[SunlitComet]

yes

 

[Uderro1]

ok wasn't sure cause Advance shows single injectors.

 

[SunlitComet]

the old style we able to be replaced individually. the new design changes thing. do not buy the old design. just get the newly redesigned assembly http://www.amazon.com/Delphi-FJ10566-Fuel-Injector/dp/B000TYLIFS