B Hag
TYF Newbie
- Joined
- Jan 11, 2017
- Posts
- 3
- Reaction score
- 0
My oil pressure gauge is not reading the correct pressure...it is either fine or too low or at 0. Does anyone have experience with a good place that does repairs?
Instrument cluster repair suggestions?
- Thread starter B Hag
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Tonyrodz
Resident Resident
Forum member @ScottyBoy repairs clusters.
95escahoe
Full Access Member
- Joined
- Aug 2, 2010
- Posts
- 5,155
- Reaction score
- 4,455
Fixmyguages.com is good too
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
BADRIDES
Full Access Member
- Joined
- Dec 18, 2015
- Posts
- 1,737
- Reaction score
- 1,152
Try an oil sending unit first
mals
Full Access Member
Seconded.
mwilson62000
Supporting Member
- Joined
- Jan 20, 2015
- Posts
- 426
- Reaction score
- 1,395
Would definitely try oil sending unit 1st. Cheap part, but pain to get to. On back of the block at the firewall.
ScottyBoy
Full Access Member
It's either the oil sending unit, or else the stepper motors are failing just like you suspected. If you know ANYONE at all with a 03-06 GM full-size truck or SUV, then I would see if you could borrow their cluster for 5 minutes to see FOR SURE if it's the cluster or not. The cluster can be removed in less than 5 minutes with a 7mm nut driver or a 1/4inch ratchet with a 7mm socket . It's just four 7mm screws and one plug on the back. If your friends cluster has the oil pressure reading the same as yours was, then you know that you need an oil sending unit. If it's NOT acting up, then you need new stepper motors in your cluster.
