Jonas's 79' CJ7 Build.....
- Thread starter Yuko04
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Thanks Nathan, you know my current situation, but it has made me aware of every moment isnt promissed.....so we move foward!
Last edited:
I have been really learning how fiberglassing and sanding,filling and feather edging works. It's a lot of fricking work. But hey the only was to learn is to get out and try......
taillights filled and ready for short hair resin..
Four different stages of sanding filling at 80 grit. 
Tail end all smoothed out at 120 grit...When you can close your eyes and run across the worked area and feel no high spots or low spots....then you are ready for primer......
Center location where previous shifter and 4wd controls were. Filled and ready for 120 grit...
Now it's time to clean the shop....She dusty!!
taillights filled and ready for short hair resin.. Four different stages of sanding filling at 80 grit. Tail end all smoothed out at 120 grit...When you can close your eyes and run across the worked area and feel no high spots or low spots....then you are ready for primer......
Center location where previous shifter and 4wd controls were. Filled and ready for 120 grit...Now it's time to clean the shop....She dusty!!
- Joined
- Jan 3, 2011
- Posts
- 50,348
- Reaction score
- 17,135
I feel dusty just looking at the pics LOL
It will be twice as long...
HiHoeSilver
Away!
Hello pot, meet kettle.
Rebuild aint the same as build.
- Joined
- Jan 3, 2011
- Posts
- 50,348
- Reaction score
- 17,135
LOL have you seen the fab work going into this "rebuild"?
PG01
Supporting Member
In my opinion, as a matter of fact.
Similar threads
