Stuck Brakes 05 tahoe z71

[Wells596]

 

[OR VietVet]

He did just the passenger side front or rear caliper? Why not both? Was the caliper done for this issue or another issue?

I would look very carefully for any wiring connection problems, corrosion, loose, pins pushed out, etc.... Check all grounds.

 

[rockola1971]

He did do the passenger caliper. All I’ve done is put a set of rear pads on it and try to diagnose the brake issue. Bled them as I thought maybe they didn’t bleed all the air out. Other than that haven’t done anything.

Is "Brake" light on when engine running? Andy ABS messages in message center? How did you bleed the brakes? Do you have a firm brake pedal with engine running? You need a scanner to identify which module(s) are throwing the U1000 code. Me thinks the ABS is a part of it and its no talky which would explain why your brakes arent releasing because you have a solenoid in the ABS manifold not being told to open/close.

 

[Wells596]

Is "Brake" light on when engine running? Andy ABS messages in message center? How did you bleed the brakes? Do you have a firm brake pedal with engine running? You need a scanner to identify which module(s) are throwing the U1000 code. Me thinks the ABS is a part of it and its no talky which would explain why your brakes arent releasing because you have a solenoid in the ABS manifold not being told to open/close.

Not until I pulled both fuses for the ABS. Now I can drive it for about 20ish minutes before they start sticking, I know these things have an issue with solder cracking is that possibly the cause? Thanks for all the help.