What did you do to your 2015-2020 K2XX Tahoe/Yukon Today?

[07Burb]

Yeah... Not my favorite thing in the world but it works still.

Nice! That's basically how I want my Denali to sit. Not slammed but just a mild drop. The Magneride is a pain, tho. What did you do to modify the rods that attach to the level sensor in the rear?

 

[Bigkevschopshop]

Nice! That's basically how I want my Denali to sit. Not slammed but just a mild drop. The Magneride is a pain, tho. What did you do to modify the rods that attach to the level sensor in the rear?

So when you pull the links, pull the plastic ends off, there is two grooves, I cut off between the two grooves so the second one now serves at the lock groove for the end plastic ball joint... I trimmed them and then ground down till they both were the same length in the caliper. I read somewhere here that .125 there is like 1" or something, hell I cant remember, so I took that figure I found and shortened them that much for 3" and has been fine.

 

[jd08]

Rotated the tires. While doing that I noticed a nail in one tire and passanger rear axle seal leaking. Hopefully the powertain warranty covers the seal.

 

[Tonyv__]

So when you pull the links, pull the plastic ends off, there is two grooves, I cut off between the two grooves so the second one now serves at the lock groove for the end plastic ball joint... I trimmed them and then ground down till they both were the same length in the caliper. I read somewhere here that .125 there is like 1" or something, hell I cant remember, so I took that figure I found and shortened them that much for 3" and has been fine.

So overall. You shortened the rod length like 0.375” ?

 

[Jeff_]

Changed the oil and gave her a nice (desperately needed) wash in the driveway.

 

[Fast_AT4]

Accepted delivery to my house and within 30 minutes this happened. Need to do a proper wash, but this was good enough to get the trailer debris off her.

 

[gat0r]

So when you pull the links, pull the plastic ends off, there is two grooves, I cut off between the two grooves so the second one now serves at the lock groove for the end plastic ball joint... I trimmed them and then ground down till they both were the same length in the caliper. I read somewhere here that .125 there is like 1" or something, hell I cant remember, so I took that figure I found and shortened them that much for 3" and has been fine.

i was told....
For every 1/8 adj. on the sensor rods changes the height 3/4".

 

[Bigkevschopshop]

I guess I was right then pretty close. .375 should equal 2.75" drop and shave a 1/32th off on grinder that's 3"

 

[Philpug]

 

[5280YUK]

Minor stuff - Front windows tinted and color matched emblems using vinyl.