What did you do to your NBS GMT800 Tahoe/Yukon Today?

[1992rs]

foreground limiter

Nah not motivated enough. You can only polish a turd so far. Being stuck with only one bulb option that has suspect quality control is lackluster at best too. Just gunna go rx350 or maybe s2000 retrofit.


Sent from my iPhone using Tapatalk

 

[Bombsquad85]

Nah not motivated enough. You can only polish a turd so far. Being stuck with only one bulb option that has suspect quality control is lackluster at best too. Just gunna go rx350 or maybe s2000 retrofit.


Sent from my iPhone using Tapatalk

The new mini d2s 5.0 looks pretty good too

 

[1992rs]

The new mini d2s 5.0 looks pretty good too

I’ll look into it! I haven’t paid much attention to the retrofit world lately.


Sent from my iPhone using Tapatalk

 

[Bombsquad85]

I’ll look into it! I haven’t paid much attention to the retrofit world lately.


Sent from my iPhone using Tapatalk

Some improvement over the 4.0 and way better than the mini h1

 

[Fosscore]

Thoughts on torquing lug nuts after you have pulled your own wheels off at home during routine maintenance, etc...

Torque wrench, impact driver or lug wrench?
Or a combination of each or only 1?

 

[eand28]

Thoughts on torquing lug nuts after you have pulled your own wheels off at home during routine maintenance, etc...

Torque wrench, impact driver or lug wrench?
Or a combination of each or only 1?

I typically run them snug with impact then torque them with a torque wrench

 

[M3kanic]

I normally tighten them up with an umph and then a week later go back over them.

Sent from my SM-G955U using Tapatalk

 

[Sam Harris]

I typically run them snug with impact then torque them with a torque wrench

This. Then re-torque after a day or so.


Sent from my iPhone using Tapatalk

 

[Fless]

This. Then re-torque after a day or so.

Sent from my iPhone using Tapatalk

^^^^^ This.

 

[Bombsquad85]

I typically run them snug with impact then torque them with a torque wrench

What do you torque your wheels to?