Wheel Spacer sizing

[DWSmoot]

Thinking about potentially adding some BORA hub centric wheel spacers. Does anyone have experience with and/or know the smallest spacers that can be run on these wheels without cutting studs?

 

[Countryboy07]

1.75"

 

[Bigmac18]

Yup... 1.75" Bora spacers were made specifically for the GM stud length

 

[DWSmoot]

So is that basically equal to a wheel with a -20 offset on these vehicles?

 

[Bigmac18]

It will push your wheel out about 44mm from where it is now, so depending on the offset of your stock wheels (+31mm?) you're probably close to a -12 offset wheel

I am running a 2" spacer with stock wheels (20x8.5 +31) and 305s just for some comparison:

 

[DWSmoot]

It will push your wheel out about 44mm from where it is now, so depending on the offset of your stock wheels (+31mm?) you're probably close to a -12 offset wheel

I am running a 2" spacer with stock wheels (20x8.5 +31) and 305s just for some comparison:

Thanks BigMac. My wheels are 22x9 24 offset. Your setup looks good. Concerned mine would push out more even with a 1.5 spacer. Do you have any other pics at different angles?

 

[Bigmac18]

with a 20x9 +24 wheel and 1.75" spacers, yours will stick approx 1/4" further out than mine pictured.

 

[Bigmac18]

 

[DWSmoot]

Big thanks BigMac! Really helps. Are you about 2” outside the well?

 

[Bigmac18]

ya, pretty close to 2"
This is without the 2 inch wheel spacers: