Would trail boss axle half shaft fit Suburban?

[LeoHighCountry]

Hello everyone ! I recently did a 3.5 inch lift on my 2021 suburban HIGH COUNTRY and my drivers side axle boot ripped already… I was looking into getting the one from the trail boss Silverado because it has a factory 2 inch lift so it’s a bit longer… is that ok? Would it fit ? Or just stick with the factory one??
Suburban part # 84754391

Trail boss part # is 85134026

Thank you very much I am very new to this…

 

[B-train]

It would definitely be worth a try. They should share similar architecture

 

[olyelr]

I would want to see them in person side by side before purchasing them to be sure all the splines and mounts are the same. Hell, they may be the same damn length.

Also, even if they are longer, i dont think that is gonna prevent that from happening again.

Nice looking ride! 35x12.5/20’s?

 

[LeoHighCountry]

It would definitely be worth a try. They should share similar architecture

That’s what I’m thinking…

 

[LeoHighCountry]

I would want to see them in person side by side before purchasing them to be sure all the splines and mounts are the same. Hell, they may be the same damn length.

Also, even if they are longer, i dont think that is gonna prevent that from happening again.

Nice looking ride! 35x12.5/20’s?

You don’t think the extra length would put less tension on them ? And yes sir !! 35/12.5/20 MT Baja BOSS tires

 

[olyelr]

You don’t think the extra length would put less tension on them ? And yes sir !! 35/12.5/20 MT Baja BOSS tires

I dont see how it would possibly change the angle of the shaft (rubber boot) enough to make a lick of a difference. Im assuming the original one already let loose because the angle is too steep.

I am guessing for that amount of lift there probably should be some type of differential drop to get the angles back in check.

 

[olyelr]

And i dont think its a big deal, but the dust shield or whatever it is called on the strut is crooked for some reason…

 

[olyelr]

What 3 1/2” kit did you go with?

 

[LeoHighCountry]

What 3 1/2” kit did you go with?

I used READYLIFT

 

[LeoHighCountry]

And i dont think its a big deal, but the dust shield or whatever it is called on the strut is crooked for some reason…

View attachment 387460

Yea I don’t think so either