Yates's Cadillac adventures
- Thread starter yates ™
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
yukondoit
Stay Classy
Mmmnn I like what I see
OP
OP
A tan color, I was going to switch out to the stainless tank that came with the system but it was slightly smaller and didn't want to drill more holes.
Eh i think you should..i think that tan looks like poo. Just my opinion.
Get a piece of metal that runs the length of the tan tank, mark the mounting holes then put you a new tank on said mounting plate. Powder the metal black and be done. stainless tank on the black powder. look good. Again just my opinion.
Get a piece of metal that runs the length of the tan tank, mark the mounting holes then put you a new tank on said mounting plate. Powder the metal black and be done. stainless tank on the black powder. look good. Again just my opinion.
OP
OP
I had considered this but you really cannot see the tank very well in the trunk and once I finish the trunk it will be hidden anyways plus the mounting holes between tanks and vertical room I have it was going to have was so close it would be a PITA if even doable. Worst case if I dislike this I will pull the tank and color match it.
10 minutes later @yates ™ now has a new wiring concealment plan and new clean compression sleeve to make it cleaner.
You are welcome buddy. Sorry I didn't tell you a week ago. As I thought you were running wires diff. We should have discussed this deeper. Just drive it and we can fix in the spring.
You are welcome buddy. Sorry I didn't tell you a week ago. As I thought you were running wires diff. We should have discussed this deeper. Just drive it and we can fix in the spring.
Done yet?
