electro
Full Access Member
Hi there,
I'm installing case saver, replacing both drive shaft seals, and probably rear bushing a bearing - IF - I can get the thing separated!
I bought a set of snap ring pliers, there not going to work at all, wrong style-completer waste of time.
My question is: Do you open or close the snap ring inside the case? The one that you need to deal with to allow the case to come apart.
Is there a more specific name for the required pliers other then, "snap ring?"
I'm looking at it, but I just cant seem to visualize what is supposed to happen inside?
ALSO, what side should I sit the tcase on that will make this easier for me?
Thanks in advance,
Ryan
I'm installing case saver, replacing both drive shaft seals, and probably rear bushing a bearing - IF - I can get the thing separated!
I bought a set of snap ring pliers, there not going to work at all, wrong style-completer waste of time.
My question is: Do you open or close the snap ring inside the case? The one that you need to deal with to allow the case to come apart.
Is there a more specific name for the required pliers other then, "snap ring?"
I'm looking at it, but I just cant seem to visualize what is supposed to happen inside?
ALSO, what side should I sit the tcase on that will make this easier for me?
Thanks in advance,
Ryan