-
-
Ccofferson replied to the thread Help with brakes before I pull my hair out.Thanks, it's not the technique that's the problem. It was the abs block with corroded valves from sitting. Verified the brakes stick...
-
Ccofferson replied to the thread Help with brakes before I pull my hair out.I have some needle nose vice grips. I might have to try this. Thank you
-
Ccofferson replied to the thread Help with brakes before I pull my hair out.I know. I'm even nervous about the line wrenches. I feel like even the best of the best snap on ones can't handle too much torque before...
-
Ccofferson replied to the thread Help with brakes before I pull my hair out.While we're here. Anyone got a trick for these rusty flare nuts? Idk why GM decided the ABS module should be here this close to the...
-
-
Ccofferson replied to the thread Help with brakes before I pull my hair out.Well I couldn't get any more air so I went for a drive and the brakes were fine BUT my initial problem of the brakes staying engaged...
-
Ccofferson replied to the thread Help with brakes before I pull my hair out.Of course. What I mean is I prefer to use a kit with hoses so I can be sure no more air is circulating. I prefer this over the "plug...
-
Ccofferson replied to the thread Help with brakes before I pull my hair out.Yes, I am using a scan tool to do the autobleed sequence.
-
Ccofferson replied to the thread Help with brakes before I pull my hair out.Basically the same as you but Orion bleeder. just your typically pump up pressure bleeder. I'd think it was impossible too but here we are.
-
Ccofferson replied to the thread Help with brakes before I pull my hair out.What I meant was that I was pressure bleeding getting no air through so I went back to a revised manual bleed to get some air through...
-
Ccofferson replied to the thread Help with brakes before I pull my hair out.Just a quick update: Over the weekend I received a replacement master cylinder and an ABS valve block. ABS valve block is put to the...
-
Ccofferson replied to the thread New hydroboost to master cylinder question.It's all good. I used the rod from the original booster in the new one once I got them apart. Doesn't really matter because I have...
-
Ccofferson replied to the thread New hydroboost to master cylinder question.And there's no adjustment so I'd have to remove the pushrod and trim.. maybe with this amount of preload they designed it to not cover...
-
Ccofferson replied to the thread New hydroboost to master cylinder question.Hey everyone. Just wanted to report back that I finally used an air hammer to separate the original booster from the original master...
-
-
Ccofferson replied to the thread Help with brakes before I pull my hair out.Haha I was the one with the gap. Unfortunately it is the right parts so idk why they didn't fit together neatly. It was ACDelco 18M2564...
-
Ccofferson replied to the thread Help with brakes before I pull my hair out.Thanks. I used a pressure bleeder as well to no avail.
-
-
Loading…
-
Loading…
